Chuango DWC-55 User Manual

Browse online or download pdf User Manual for Accessories Chuango DWC-55. Chuango DWC-55 2 pages. Roller shutter door sensor

Print Page

Roller Shutter

Door Sensor

DWC-55

User Manual

Introduction

The DWC-55 Roller Shutter Door Sensor is used for rolling gates.

When the Metal Magnet and the Metal Reed Switch are

separated more than 2cm, it will transmit wireless alert signal to

the connected control panel immediately. The lifespan of the

battery depends on the frequency of opening and closing the

door/gate, the normal battery's service life is about 12 to 15

months.

Product Overview

Metal Reed Switch

Metal Magnet

All manuals and user guides at all-guides.com

LED Indication

Flashes once:

Door opening is detected.

Flashes once every 3 seconds:

the batteries as soon as possible.

Pair with Control Panel

1. Make sure the control panel enters Pairing Accessory State

(Please refer to the details in the control panel's user manual)

2. Separate the Metal Magnet and the Metal Reed Switch for more

than 2cm. The control panel beeps once to indicate a successful

pairing.

Installation

Antenna

LED

Indicator

Important:

Transmitter

Please test the sensor to make sure the connected control panel

can receive the transmitting signal of the sensor before fixing it in

place.

Low power indication; please change

Install the sensor inside the house.

Steps:

1. Metal magnet:

Install it on the bottom of the rolling gate which

can move up and down, it should be parallel to the ground but

don't over the bottom.

2. Metal reed switch:

Install it on the ground and make sure the

distance between the metal magnet is less than 2cm.

3. Transmitter:

It is connected with the metal reed switch and

should be mounted on the wall beside the rolling gate (Away from

the gate as far as possible because metal may disturb wireless

transmission).

4. Test:

Set the control panel to Arm State, close the gate and

open it over 2cm, the sensor is working well if the LED indicator

flashes once and the system alarm goes off.

Note:

If only LED indicator flashes once but the system alarm does not go

off, please pull out the antenna of DWC-55 or move the control panel a

little closer to the sensor.

Specifications

BatteryDC 3V (AAA 1.5V LR03 x 2 PCS)

<23 uA

Static Current

<40 mA

Alarm Current

<80m (in open area)

Transmitting Distance

Radio Frequency

315 MHz/433.92MHz (±75KHz)

Housing

MaterialABS plastic

Operation

ConditionTemperature -10°C~+55°C

Relative Humidity<80% (non-condensing)

105.5 X 15.5 X15.5 mm

Metal Magnet Dimensions (L x W x H)

105.5 X 38 X 9.6 mm

Metal Reed Switch Dimensions (L x W x H)

107 X 54 X 14.5 mm

Transmitter Dimensions (L x W x H)

Ver : DWC-55-UM-EN-V1.0

2016 Chuango. All rights reser ved.