Panasonic WV-SP105 Installation Manual - Page 13

Browse online or download pdf Installation Manual for Camcorder Panasonic WV-SP105. Panasonic WV-SP105 36 pages. Ip video cameras
Also for Panasonic WV-SP105: Specifications (2 pages), Specifications (2 pages), Datasheet (2 pages), Comparison Chart (6 pages), Integration Note (8 pages)

Print Page

Precautions for Installation

No responsibility will be taken by our com-

pany with respect to consequeces result-

ing from the use, damage or both of the

camera.

This product is designed to be used

indoors.

The product is not operable outdoors.

Do not expose the product to direct sunlight for

hours and do not install the product near a

heater or an air conditioner. Otherwise, it may

cause deformation, discoloration and malfunc-

tion. Keep the product away from water and

moisture.

Installation place

Do not place this product in the following plac-

es:

• Locations where it may get wet from rain

or water splash

• Locations where a chemical agent is used

such as a swimming pool

• Locations subject to humidity, dust, steam

and oil smoke

• Locations in a specific environment where

a solvent or a flammable atmosphere

exists

• Locations where a radiation, an X-ray, a

strong radio wave or a strong magnetic

field is generated

• Locations where corrosive gas is pro-

duced, locations where it may be damaged

by briny air such as seashores

• Locations where the temperature is not

within 0 °C to +40 °C {32 °F to 104 °F}.

• Locations subject to vibrations (This prod-

uct is not designed for on-vehicle use.)

• Locations subject to condensation as the

result of severe changes in temperature

Be sure to remove this product if it is not

in use.

Before installation

• The locally procured camera mount brack-

et shall be used to mount this product.

• When the product and camera mount

bracket are mounted on a ceiling or a wall,

use the screws described on page 17. The

screws to be used are not provided.

Prepare the screws according to the mate-

rial, structure, strength and other factors of

the mounting area and the total weight of

objects to be mounted.

• Ensure that the mounting surface, anchor

and screws are sufficiently strong.

• Do not mount the product on a plaster

board or a wooden section because they

are too weak. If this product is unavoidably

mounted on such a section, the section

shall be sufficiently reinforced.

Screw tightening

• The screws and bolts must be tightened

with an appropriate tightening torque

according to the material and strength of

the installation area.

• Do not use an impact driver. Use of an

impact driver may damage the screws or

cause tightening excessively.

• When a screw is tightened, make the

screw at a right angle to the surface. After

tightening the screws or bolts, perform

visual check to ensure tightening is enough

and there is no backlash.

Fall prevention measures

When the external safety wire is connected,

select a connection point resulting in that noth-

ing will hit people after the mount bracket is

damaged. The wire length shall be adjusted to

remove slack.