Panasonic WV-SW314 Installation Manual - Page 14
Browse online or download pdf Installation Manual for Camcorder Panasonic WV-SW314. Panasonic WV-SW314 50 pages. Ip video cameras
Also for Panasonic WV-SW314: Specification (2 pages), Integration Note (8 pages)
Print Page
Precautions for installation
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documenta-
tion.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• If a wall or ceiling board such as plaster
board is too weak to support the total
weight, the area shall be sufficiently rein-
forced.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to oil smoke such as a
kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations where corrosive gas is pro-
duced, locations where it may be damaged
by briny air such as seashores
• Locations where the temperature is not
within the specified range (page 43).
• Locations subject to vibrations (This prod-
uct is not designed for on-vehicle use.)
Be sure to remove this product if it is not
in use.
14
Design and engineer the power supply
system to turn on/off the power of this
product.
The product has no power switch. When
installing the product, use a power supply
device equipped with the ON-OFF switch for
servicing.
About the network connection
When connecting to a network using the network
cable of this product, observe the following.
• When wiring for the network, design and
engineer not to be affected by thunder.
• It is impossible to install this product in
combination with a pan/tilt head.
Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.
• Tighten screws at a right angle to the sur-
face. After tightening screws, perform visu-
al check to ensure tightening is so suffi-
cient that there is no backlash.
The measures of protection against a fall
of this product shall be taken.
Failure to observe this may cause a drop resulting
in injury or accidents. Be sure to install the safety
wire.
Procure fixing screws separately.
The screws that secure this product are not
supplied. Prepare them according to the mate-
rial and strength of the area where the product
is to be installed.