Panasonic WV-SW395 Installation Manual - Page 21

Browse online or download pdf Installation Manual for Camcorder Panasonic WV-SW395. Panasonic WV-SW395 40 pages. Ip video cameras
Also for Panasonic WV-SW395: Specifications (2 pages), Brochure (2 pages), Comparison Chart (6 pages), Installation Manual (40 pages), Installation Manual (40 pages), Integration Note (8 pages)

Print Page
Panasonic WV-SW395 Installation Manual
Step 4
Mount the camera on the bracket.
q Attach the housing base to the mount bracket using
the hexagon screws (M5) attached to the housing
base* provided with the mount bracket.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf·ft})
The "REAR" mark of the housing base shall be direct-
ed to the wire hook section.
* Special screw: These screws are hexagon screws.
Use an M5 hexagon wrench.
Hexagon screws (M5, 4 pcs.)
attached to the housing base
Housing base
w Make sure that the projection of the plate spring on
the upper side of the camera is located on the
"START" position. If not, turn the plate clockwise to
locate the projection at the "START" position.
Plate spring
Plate
e Connect the safety wire (accessory) to the mount bracket.
Refer to the operating instructions of the mount
bracket for further information about where to con-
nect the safety wire.
Even when not using the optional mounting bracket
(WV-Q122A), connect the safety wire near to the cam-
era as shown in the example below.
<Installation example>
r Attach the camera to the housing base. When attach-
Wire hook
section
Projection
ing the camera to the housing base, the positioning pin
shall be on the "REAR" side. Make sure that the camera
is securely attached to the mount bracket by turning the
camera to the direction of the arrow as illustrated. Then,
secure the camera to the mount bracket with the
screws removed when detaching the housing base.
(Recommended tightening torque: 2.45 N·m {1.81 lbf·ft})
* Special screw (Fixing screw): These screws are hexa-
gon screws. Use an M5 hexagon wrench.
<Overhead view>
Positioning pin
When the camera is
attached
Housing base
Positioning pin
Camera
Protection Cover
SW395A
SW396A
Safety wire
When the camera is secured
to the mount bracket
Fixing screws (3 pcs.)
21