Panasonic WV-SW396 Installation Manual - Page 21

Browse online or download pdf Installation Manual for Camcorder Panasonic WV-SW396. Panasonic WV-SW396 40 pages. Ip video cameras
Also for Panasonic WV-SW396: Specification (2 pages), Installation Manual (40 pages), Speci?Cations (2 pages), Integration Note (8 pages)

Print Page

Step 4

Mount the camera on the bracket.

q Attach the housing base to the mount bracket using

the hexagon screws (M5) attached to the housing

base* provided with the mount bracket.

(Recommended tightening torque: 2.45 N·m

{1.81 lbf·ft})

The "REAR" mark of the housing base shall be direct-

ed to the wire hook section.

* Special screw: These screws are hexagon screws.

Use an M5 hexagon wrench.

Hexagon screws (M5, 4 pcs.)

attached to the housing base

Housing base

w Make sure that the projection of the plate spring on

the upper side of the camera is located on the

"START" position. If not, turn the plate clockwise to

locate the projection at the "START" position.

Plate spring

Plate

e Connect the safety wire (accessory) to the mount bracket.

Refer to the operating instructions of the mount

bracket for further information about where to con-

nect the safety wire.

Even when not using the optional mounting bracket

(WV-Q122A), connect the safety wire near to the cam-

era as shown in the example below.

r Attach the camera to the housing base. When attach-

Wire hook

section

Projection

ing the camera to the housing base, the positioning pin

shall be on the "REAR" side. Make sure that the camera

is securely attached to the mount bracket by turning the

camera to the direction of the arrow as illustrated. Then,

secure the camera to the mount bracket with the

screws removed when detaching the housing base.

(Recommended tightening torque: 2.45 N·m {1.81 lbf·ft})

* Special screw (Fixing screw): These screws are hexa-

gon screws. Use an M5 hexagon wrench.

Positioning pin

When the camera is

attached

Housing base

Positioning pin

Camera

Protection Cover

SW395A

SW396A

Safety wire

When the camera is secured

to the mount bracket

Fixing screws (3 pcs.)