AquaSure AS-FP1000 Owner's Manual - Page 5
Browse online or download pdf Owner's Manual for Water Filtration Systems AquaSure AS-FP1000. AquaSure AS-FP1000 12 pages. Whole house water filter
Print Page
- 1. Table of Contents
- 2. Inspection & Preparation
- 3. Be Familiar with the System before Installation
- 4. System Operation Parameter and Installation Checklist
- 5. Installing the System
- 6. STEP 1. Checking the Direction of Water Flow
- 7. STEP 2. Shutting off the Main Water Supply Valve
- 8. STEP 4. Attaching the Water Supply Pipe
- 9. STEP 5. Installing the Filter
- 10. STEP 6. System Startup
- 11. Limited Product Warranty
II. System Operation Parameter and Installation checklist
IMPORTANT! The following condition for feed water supply must be met or warranty will be
void and manufacturer assumes no responsibility for damage to system or property.
1. Water Temperature Parameter
•
Maximum: 100º F (37.8º C)
•
Minimum: 40º F (4.4º C)
2. Water Pressure Parameter
•
Maximum: 75 PSI (5.98 kg/cm2)
•
Minimum: 20 PSI (1.41 kg/cm2)
3. pH Parameter
•
Maximum: 10
•
Minimum: 5
4. Pre-install environment checklist
•
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
•
Filtration system must not be installed at an area where it is exposed to direct sunlight
and must be protected against freezing and extreme heat.
•
To prevent possible water damage, housing should be replaced every 4 years.
AQUASURE
FORTITUDE PRO SERIES
3