HP 1910-48 Datasheet - Page 14
Browse online or download pdf Datasheet for Switch HP 1910-48. HP 1910-48 16 pages. 1910 switch series
Also for HP 1910-48: Quickspecs (43 pages), Quickspecs (44 pages), Getting Started Manual (26 pages)
Print Page
HP 1910 Switch Series
Specifications (continued)
Ports
Physical characteristics
Weight
Memory and processor
Mounting
Performance
100 Mb Latency
1000 Mb Latency
Throughput
Routing/Switching capacity
Routing table size
MAC address table size
Environment
Operating temperature
Operating relative humidity
Nonoperating/Storage temperature
Nonoperating/Storage relative humidity 10% to 95%, noncondensing
Electrical characteristics
Frequency
Voltage
Maximum power rating
PoE power
Notes
Safety
Emissions
Management
Notes
Services
14
HP 1910-8-PoE+ Switch (JG537A)
8 RJ-45 autosensing 10/100 PoE+ ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type
100BASE-TX, IEEE 802.3at PoE+); Duplex: half or full
2 SFP dual-personality 1000 Mbps ports (IEEE 802.3ab Type 1000BASE-T)
1 RJ-45 console port to access limited CLI port
Supports a maximum of 8 autosensing 10/100 ports plus 2 1000BASE-X SFP ports, or
a combination
12.99(w) x 9.06(d) x 1.73(h) in (33 x 23 x 4.4 cm) (1U height)
4.63 lb (2.1 kg)
MIPS @ 500 MHz, 32 MB flash, 128 MB RAM; packet buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 4.2 Mpps (64-byte packets)
5.6 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 104°F (0°C to 40°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
50/60 Hz
100-240 VAC
90 W
62 W
Maximum power rating and maximum heat dissipation are the worst-case theoretical
maximum numbers provided for planning the infrastructure with fully loaded PoE (if
equipped), 100% traffic, all ports plugged in, and all modules populated.
PoE power is the power supplied by the internal power supply. It is dependent on the
type and quantity of power supplies and may be supplemented with the use of an
external power supply (EPS).
IEC 60950-1; EN 60950-1; UL 60950-1 2nd Edition; CSA C22.2 No. 60950-1-07 2nd
Edition
FCC part 15 Class A; VCCI Class A; EN 55022 Class A; CISPR 22 Class A; EN 55024; EN
61000-3-2 2000, 61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited command-line interface; Web browser;
SNMP Manager; IEEE 802.3 Ethernet MIB
The HP 1910-24G Switch (JE006A) was formerly sold as the 3Com Baseline Plus 2928
(3CRBSG2893) and may ship with this product labeling.
SFP ports and copper ports can work simultaneously, independent of each other, to
provide a total of 28 Gigabit Ethernet-capable ports.
Refer to the HP website at www.hp.com/networking/services for details on the
service-level descriptions and product numbers. For details about services and
response times in your area, please contact your local HP sales office.
HP 1910-24-PoE+ Switch (JG539A)
24 RJ-45 autosensing 10/100 PoE+ ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u
Type 100BASE-TX, IEEE 802.3at PoE+); Duplex: half or full
2 SFP dual-personality 1000 Mbps ports (IEEE 802.3ab Type 1000BASE-T)
1 RJ-45 console port to access limited CLI port
Supports a maximum of 24 autosensing 10/100 ports plus 2 1000BASE-X SFP ports, or
a combination
17.32(w) x 9.37(d) x 1.73(h) in (44 x 23.8 x 4.4 cm) (1U height)
7.28 lb (3.3 kg)
MIPS @ 500 MHz, 32 MB flash, 128 MB RAM; packet buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 6.6 Mpps (64-byte packets)
8.8 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 104°F (0°C to 40°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
10% to 95%, noncondensing
50/60 Hz
100-240 VAC
220 W
180 W
Maximum power rating and maximum heat dissipation are the worst-case theoretical
maximum numbers provided for planning the infrastructure with fully loaded PoE (if
equipped), 100% traffic, all ports plugged in, and all modules populated.
PoE power is the power supplied by the internal power supply. It is dependent on the
type and quantity of power supplies and may be supplemented with the use of an
external power supply (EPS).
IEC 60950-1; EN 60950-1; UL 60950-1 2nd Edition; CSA C22.2 No. 60950-1-07 2nd
Edition
FCC part 15 Class A; VCCI Class A; EN 55022 Class A; CISPR 22 Class A; EN 55024; EN
61000-3-2 2000, 61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited command-line interface; Web browser;
SNMP Manager; IEEE 802.3 Ethernet MIB
The HP 1910-24G Switch (JE006A) was formerly sold as the 3Com Baseline Plus 2928
(3CRBSG2893) and may ship with this product labeling.
SFP ports and copper ports can work simultaneously, independent of each other, to
provide a total of 28 Gigabit Ethernet-capable ports.
Refer to the HP website at www.hp.com/networking/services for details on the
service-level descriptions and product numbers. For details about services and
response times in your area, please contact your local HP sales office.