HP 3100-48 v2 Installation Manual - Page 42
Browse online or download pdf Installation Manual for Switch HP 3100-48 v2. HP 3100-48 v2 47 pages.
Print Page
LED
10/100Base-TX Ethernet port LED
Each 10/100Base-TX auto-sensing Ethernet port has a status LED to show port operating status and
activities. The port mode LED shows the type of port status information (for example, port rate or duplex
mode) that the port status LEDs are showing. You can use the port status LED mode switching button to
change the type of displayed port information.
Table 15 10/100Base-TX auto-sensing Ethernet port LED description
Status
Port mode LED
Steady green (rate
mode)
Status
System status
Seven-segment (Unit) LED
LED (SYS)
The LED displays a flashing F
character.
Steady red
The LED displays a flashing t
character.
Steady red
The LED displays a capital C
character.
The LED displays an S character.
Steady green
The LED displays a lowercase c
character.
The LED displays a number.
Port status LED
Steady green
Steady yellow
Flashing yellow (3
Hz)
Off
Description
The port is operating at 100 Mbps. The port status LED fast
flashes when the port is sending or receiving data.
The port is operating at 10 Mbps. The port status LED fast
flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
38
Description
The switch is experiencing a fan
failure.
The switch is in an over-temperature
condition.
The switch is the command switch in
a cluster.
The switch is a member switch in a
cluster.
The switch is a candidate switch for
a cluster.
The member ID of the switch.