HP 5120-24G-PoE+ EI Configuration Manual - Page 33
Browse online or download pdf Configuration Manual for Switch HP 5120-24G-PoE+ EI. HP 5120-24G-PoE+ EI 39 pages. Hp 5120 ei switch series
Also for HP 5120-24G-PoE+ EI: Datasheet (17 pages)
Print Page
[Current domain is: 0]:
The assigned
Info: MAD LACP only enable on dynamic aggregation interface.
# Assign ports GigabitEthernet 1/0/1 and GigabitEthernet 2/0/1 to the aggregate interface.
[DeviceA] interface range gigabitethernet 1/0/1 gigabitethernet 2/0/1
[DeviceA-if-range] port link-aggregation group 2
[DeviceA-if-range] quit
[DeviceA] interface gigabitethernet 2/0/1
[DeviceA-GigabitEthernet2/0/1] port link-aggregation group 2
Configure Device C as the intermediate device:
5.
# Create a dynamic aggregate interface.
<DeviceC> system-view
[DeviceC] interface bridge-aggregation 2
[DeviceC-Bridge-Aggregation2] link-aggregation mode dynamic
[DeviceC-Bridge-Aggregation2] quit
# Assign ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to the aggregate interface.
[DeviceC] interface gigabitethernet 1/0/1
[DeviceC-GigabitEthernet1/0/1] port link-aggregation group 2
[DeviceC-GigabitEthernet1/0/1] quit
[DeviceC] interface gigabitethernet 1/0/2
[DeviceC-GigabitEthernet1/0/2] port link-aggregation group 2
ARP MAD-enabled IRF configuration example
Network requirements
Set up an IRF fabric in the enterprise network in
the links connected to Device C for transmitting ARP MAD packets. To prevent loops, run the spanning
tree feature between Device C and the IRF fabric.
Figure 13 Network diagram
domain ID is: 0
29
Figure
13. Configure ARP MAD in the IRF fabric and use