HP ProCurve J8766A Read Me First - Page 3

Browse online or download pdf Read Me First for Switch HP ProCurve J8766A. HP ProCurve J8766A 4 pages. Hp procurve switch vl modules
Also for HP ProCurve J8766A: Quick Reference Manual (44 pages), Installation Manual (48 pages)

Print Page

Saving the Configuration After Installing or Exchanging a Module

The following cases automatically result in a change to the running-configuration on your switch:

If you replace a module with another module of a different type and then reboot the switch

■

If you install a module in a slot that has not previously been used (including when you install

■

a module and apply power to the switch for the first time)

If you want to save such changes to permanent memory (startup-configuration), use the write memory

command in the switch console. This causes the switch to use the new hardware configuration for

subsequent reboots. (The switch always reboots from the startup-configuration.)

If you do not save the hardware changes to the startup-configuration, you will be prompted with the

following message the next time you use the reboot or reload commands:

Do you want to save the current configuration [y/n]?

For more information on switch memory, including the startup-config and running-config memories,

refer to the Management and Configuration Guide for your switch. See "View or Download the

Manual Set" on page 1.