HP ProCurve J8766A Installation Manual - Page 17

Browse online or download pdf Installation Manual for Switch HP ProCurve J8766A. HP ProCurve J8766A 48 pages. Hp procurve switch vl modules
Also for HP ProCurve J8766A: Read Me First (4 pages), Quick Reference Manual (44 pages)

Print Page

N o t e

Install or Remove a Transceiver

Hot swapping transceivers is supported. You can install or remove a trans-

ceiver with the switch powered on, a reset will not occur.

a. Slide the transceiver in until it stops.

Figure 7. Installing an X2 transceiver

b. Push firmly until the gasket seats against the bulkhead. The transceiver

should "click" into place.

Figure 8. X2 transceiver fully installed

If the switch is powered on when the transceiver is installed, the Link and

Mode LEDs will come on for approximately two seconds and then go off. This

is confirmation the transceiver is completely seated.

c. If your transceiver has a bail, move the bail up, if not your transceiver is

now completely installed.

Refer to page 30 for more transceiver details.

To remove the transceiver:

If your transceiver has a bail, lower the bail until it is approximately horizontal,

and then using the bail, pull the transceiver from the slot. If your transceiver

does not have a bail, pull the transceiver straight out.

ProCurve Switch vl Modules

Installing the Modules