HP StorageWorks 2/32 - SAN Switch Installation Instructions Manual - Page 3

Browse online or download pdf Installation Instructions Manual for Switch HP StorageWorks 2/32 - SAN Switch. HP StorageWorks 2/32 - SAN Switch 6 pages. Fabric manager version 3.0.x release notes
Also for HP StorageWorks 2/32 - SAN Switch: Installation Instructions Manual (20 pages), User Manual (22 pages), Firmware Release Notes (14 pages), Release Note (48 pages), Release Note (32 pages), Release Note (14 pages), Release Note (4 pages)

Print Page

Item

Description

Eight #10 adapter washers

Two 1/4-20 hex nuts with

captive star lock washers

Two 1/4-inch flat washers

CAUTION:

For proper airflow, the SFP+ media side of the device port side

must face the rear of the rack. This allows cool air to enter the

front of the rack and exit from the rear.

To install the device in a rack:

Verify that the required parts and hardware are available. (See

Table

1.)

Choose a mounting location for the device in the rack.

Attach the rear mounting brackets to the rear rack uprights.

• For an HP 10000 Series Rack, assemble each of the brackets

using two #10-32 x 1/2-inch Phillips panhead screws with

captive star lock washers and two #10 adapter washers, as

shown in

Figure

• For an HP System/e Rack, install the two rear mounting brackets

with two #10-32 x 1/2-inch Phillips panhead screws and two

#10 alignment washers, as shown in

Figure 1 Installing the rear mounting brackets (HP 10000 Series

Rack)

Figure 2 Installing the rear mounting brackets (HP System/e Rack)

NOTE:

The SAN Switch Rack Mount Kit contains rails labeled

Left and Right to designate the left side and right side

of the device or cabinet as viewed from the front of the

cabinet.

Page 3

Figure