HP StorageWorks 8/8 - SAN Switch Release Note - Page 25
Browse online or download pdf Release Note for Switch HP StorageWorks 8/8 - SAN Switch. HP StorageWorks 8/8 - SAN Switch 43 pages. Hp storageworks fabric os 6.1.2b release notes (5697-0351, march 2010)
Also for HP StorageWorks 8/8 - SAN Switch: Release Note (30 pages), Release Note (29 pages), Release Note (32 pages)
Print Page
Table 6 portcfgfillword command summary
Fabric OS version
Any Fabric OS earlier than 6.1.2
FOS 6.2.0x prior to 6.2.0c
6.1.2x and 6.2.0c and later (HP
did not support 6.2.0c)
6.1.2x and 6.2.0d through 6.2.x
Mode:
1
6.1.2x was not supported on EVA4400 embedded switch module.
2
6.1.2x was not supported on this switch.
Web Tools functionality Moved to DCFM
The functionality that was moved from Web tools in 6.1.1 to DCFM is applicable to both DCFM
Professional and DCFM Enterprise and is also applicable to 6.2.x.
Table 7 Web Tools functionality in DCFM
Function
Add unzoned devices
All 8-Gb switches (except 8-Gb
SAN Switch for HP BladeSystem
c-Class)
All ports set to idles. No arb(ff)
capability existed.
Arb(ff) by default on all ports and
can't be changed.
Added the ability to change portcfg-
fillword to idle or arb(ff).
All ports default to idle [mode 0]
regardless of what FOS was previ-
ously installed, unless manually
changed to arb(ff) previously [mode
1], then it will remain arb(ff). Can
be changed by the user.
0—IDLE for Link Init, IDLE for fill
word
1—ARB(FF) for Link Init, ARB(FF) for
fill word (NOTE: not supported with
XP storage arrays)
Web Tools 6.1.0
Zone Admin
HP StorageWorks Fabric OS 6.2.0b release notes
8-Gb SAN Switch for HP
BladeSystem c-Class
All ports set to idles. No arb(ff)
1
capability existed.
All ports default to arb(ff) (internal
and external) and can't be
changed.
Added the ability to change portcfg-
1
fillword to idle or arb(ff).
If 6.2.0d was installed in the
factory, all internal ports remain
at arb(ff) [mode 1], external
ports at idle [mode 0]. Can be
changed by the user.
If pre-6.2.0d was installed in the
factory, all internal and external
ports remain at idle [mode 0],
unless they were manually
changed to arb(ff) [mode 1],
then they remain at arb(ff). Can
be changed by the user.
Table 7
DCFM
Configure > Zoning
Reverse Find in the zoning dialog
provides the view of the zoned
and unzoned devices in the fabric
is all zone members are selected
for Find.
2
2
specifies these changes.
Comments
25