HP StorageWorks 8B - FC Entry Switch Installation Manual - Page 12

Browse online or download pdf Installation Manual for Switch HP StorageWorks 8B - FC Entry Switch. HP StorageWorks 8B - FC Entry Switch 14 pages. Fabric os release notes version 3.0.1b
Also for HP StorageWorks 8B - FC Entry Switch: Update Manual (9 pages), Installation Instructions Manual (20 pages), User Manual (22 pages), Firmware Release Notes (14 pages), Release Note (26 pages), Manual (50 pages), User Manual (44 pages), User Manual (44 pages), User Manual (38 pages), User Manual (38 pages), User Manual (37 pages), User Manual (30 pages), Release Note (16 pages)

Print Page

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

Note:

is installed in the HP System/e rack. The plenum is not needed if the switch is installed

in an HP 9000 Series or comparable EIA rack.

Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch

2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount

only, as it allows air to dissipate at the rear of the rack, preventing overheating.

If the plenum is not preinstalled on the SAN Switch 2/8, refer to the HP StorageWorks

SAN Switch 2/8 Version 3.1.x Installation Guide for complete plenum installation

instructions.

Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum

Addendum Pg

b. For the SAN Switch 2/8, assemble the two inner rails (one on each side)

to the switch and plenum using the appropriate number (from

#8-32 x 3/16-inch Phillips pan-head screws as shown in

The plenum is only a required part of this installation when the SAN Switch 2/8

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

step

5) of

Figure