HP StorageWorks director 2/140 Installation Instructions Manual - Page 17
Browse online or download pdf Installation Instructions Manual for Switch HP StorageWorks director 2/140. HP StorageWorks director 2/140 22 pages. Universal port module kit
Also for HP StorageWorks director 2/140: Installation Instructions Manual (24 pages)
Print Page
Installing Shelf Brackets in an HP Rack System/e or 19-inch
EIA Rack
The shelf brackets mount directly to the interior vertical rails of the HP rack system/e
or 19-inch EIA rack using cage nuts and Phillips panhead screws.
Use these steps to install the two shelf brackets in an HP rack system/e or 19-inch EIA
rack.
1. Determine the appropriate placement for the Director inside the rack.
NOTE: HP strongly recommends installing the Director 2/140 in the lowest position in the rack.
2. Along an exterior vertical rail of the rack cabinet, determine the position of the
bottom of the shelf bracket and count 1 U up from this location.
3. Use a straight edge to locate the corresponding rack holes along the interior
vertical rails of the rack cabinet. Mark this location on each interior vertical rail.
4. Install two cage nuts along one interior vertical rail as marked in
one empty rack hole between the cage nuts.
5. Repeat
step 4
6. Secure a shelf bracket to the interior vertical rails using four (4) Phillips panhead
screws with split lock and flat washers.
7. Repeat
step 6
8. Continue to
director 2/140 rack mount kit installation instructions
for each of the three remaining interior vertical rails.
to secure the second shelf bracket on the opposite side of the rack.
"Attaching the Mounting Hardware to the Director
Installation Instructions
step
3, leaving
2/140" on page 8.
7