HP StorageWorks XP10000 - Disk Array Configuration Manual - Page 14

Browse online or download pdf Configuration Manual for Switch HP StorageWorks XP10000 - Disk Array. HP StorageWorks XP10000 - Disk Array 36 pages. Cache lun xp
Also for HP StorageWorks XP10000 - Disk Array: Release Note (13 pages), Administrator's Manual (50 pages), Configuration Manual (42 pages), Configuration Manual (40 pages), Configuration Manual (40 pages), Configuration Manual (36 pages), Configuration Manual (30 pages), Configuration Manual (36 pages), Release Note (5 pages), System Configuration Manual (49 pages), System Configuration Manual (43 pages), System Configuration Manual (42 pages), System Configuration Manual (35 pages), Configuration Manual (46 pages), Configuration Manual (46 pages), Configuration Manual (40 pages), Configuration Manual (44 pages), Configuration Manual (38 pages), Configuration Manual (34 pages), Configuration Manual (30 pages), Configuration Manual (30 pages), Configuration Manual (42 pages), User Manual (30 pages)

Print Page
HP StorageWorks XP10000 - Disk Array Configuration Manual
CAUTION:
The correct host mode must be set for all new installations (newly connected ports) to OpenVMS hosts.
Do not select a mode other than 05 for OpenVMS. Changing a host mode after the host has been
connected is disruptive and requires the server to be rebooted.

Setting the system option modes

The HP service representative sets the system option mode(s) based on the operating system and
software configuration of the host. Notify your HP representative if you install storage agnostic software
(such as backup or cluster software) that may require specific settings.

Configuring the Fibre Channel ports

Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown), or XP
Command View. Select the settings for each port based on your storage area network topology. Use
switch zoning if you connect different types of hosts to the array through the same switch. For detailed
procedures, refer to HP StorageWorks XP LUN Manager User's Guide.

Fibre address

In fabric environments, the port addresses are assigned automatically.

Fabric and connection parameter settings

Set each array port to FABRIC ENABLE with connections of POINT-TO-POINT (P-to-P). For detailed
topology information, refer to the HP StorageWorks SAN Design Reference Guide
www.hp.com/go/sandesign).
14
Installing and configuring OpenVMS for the XP disk array
(http://