HP StorageWorks XP10000 - Disk Array Configuration Manual - Page 15

Browse online or download pdf Configuration Manual for Switch HP StorageWorks XP10000 - Disk Array. HP StorageWorks XP10000 - Disk Array 46 pages. Cache lun xp
Also for HP StorageWorks XP10000 - Disk Array: Release Note (13 pages), Administrator's Manual (50 pages), Configuration Manual (42 pages), Configuration Manual (40 pages), Configuration Manual (40 pages), Configuration Manual (36 pages), Configuration Manual (36 pages), Configuration Manual (30 pages), Configuration Manual (36 pages), Release Note (5 pages), System Configuration Manual (49 pages), System Configuration Manual (43 pages), System Configuration Manual (42 pages), System Configuration Manual (35 pages), Configuration Manual (46 pages), Configuration Manual (40 pages), Configuration Manual (44 pages), Configuration Manual (38 pages), Configuration Manual (34 pages), Configuration Manual (30 pages), Configuration Manual (30 pages), Configuration Manual (42 pages), User Manual (30 pages)

Print Page
HP StorageWorks XP10000 - Disk Array Configuration Manual
Figure 2 Point-to-point fabric topology example
.
Table 2 Fabric topology settings
Fabric parameter
ON
OFF
ON
OFF

Installing and configuring the host

This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the
host to the disk array.

Loading the operating system and software

Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the FCA manufacturer.

Installing and configuring the FCAs

Install and configure the FCA driver software and setup utilities according to the manufacturer's
instructions. Configuration settings specific to the XP array differ depending on the manufacturer.
Specific configuration information is detailed below.

WWN

The FCA configuration process might require you to enter the WWN for the array port(s) to which
the FCA connects. Your HP representative can provide you this information or you can display this
information on the SAN switch.
Connection parameter
FC-AL
FC-AL
POINT-TO-POINT
POINT-TO-POINT
XP Disk Array Configuration Guide: Solaris
Provides
Legacy support only (FL-port (public loop) for
loop connection to a switch)
NL-port (private arbitrated loop) for direct
connect
F-port (fabric port) for connection to a switch
Not supported
15