HP XP20000/XP24000 Configuration Manual - Page 16

Browse online or download pdf Configuration Manual for Switch HP XP20000/XP24000. HP XP20000/XP24000 42 pages. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Also for HP XP20000/XP24000: Release Note (13 pages), Integration Manual (29 pages), Release Note (4 pages), Administrator's Manual (50 pages), Configuration Manual (40 pages), Configuration Manual (40 pages), Configuration Manual (36 pages), Configuration Manual (36 pages), Configuration Manual (30 pages), Configuration Manual (36 pages), Release Note (5 pages), Configuration Manual (46 pages), Configuration Manual (46 pages), Reference Manual (46 pages), Configuration Manual (40 pages), Configuration Manual (44 pages), Configuration Manual (38 pages), Configuration Manual (34 pages), Configuration Manual (30 pages), Configuration Manual (30 pages)

Print Page

mpxio-disable="no";

For all Solaris releases, add the following lines:

device-type-scsi-options-list =

"HP

OPEN", "symmetric-option";

symmetric-option = 0x1000000;

NOTE:

There must be exactly 6 spaces between HP and OPEN.

Instead of using the default round-robin algorithm, add the following lines in addition to the previous

lines for systems with a large amount of sequential I/O activity:

device-type-mpxio-options-list=

"device-type=HP

logical-block-options="load-balance=logical-block", "region-size=18";

NOTE:

There must be exactly 6 spaces between HP and OPEN.

For further information see document IDs 76504 and 76505 at http://sunsolve.sun.com.

For Solaris 8/9, perform a reconfiguration reboot of the host to implement changes to the config-

uration file. For Solaris 10, use the stmsboot command which will perform the modifications

and then initiate a reboot.

For Solaris 8/9, after you have rebooted and the LDEV has been defined as a LUN to the host,

use the cfgadm command to configure the controller instances for SAN connectivity. The controller

instance (c#) may differ between systems. Replace the WWPN in the example below with the

WWPNs for your array ports.

Example

# cfgadm -al

Ap_Id

Type Receptacle Occupant Condition

c3 fc-fabric connected configured unknown

c3::50060e8003285301 disk connected configured unknown

c4 fc-fabric connected configured unknown

c4::50060e8003285311 disk connected configured unknown

# cfgadm -c configure c3::50060e8003285301

# cfgadm -c configure c4::50060e8003285311

Installing and configuring Sun Solaris for the XP disk array

OPEN", "load-balance-options=logical-block-options";