HP XP20000/XP24000 Configuration Manual - Page 22

Browse online or download pdf Configuration Manual for Switch HP XP20000/XP24000. HP XP20000/XP24000 40 pages. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Also for HP XP20000/XP24000: Release Note (13 pages), Integration Manual (29 pages), Release Note (4 pages), Administrator's Manual (50 pages), Configuration Manual (42 pages), Configuration Manual (40 pages), Configuration Manual (36 pages), Configuration Manual (36 pages), Configuration Manual (30 pages), Configuration Manual (36 pages), Release Note (5 pages), Configuration Manual (46 pages), Configuration Manual (46 pages), Reference Manual (46 pages), Configuration Manual (40 pages), Configuration Manual (44 pages), Configuration Manual (38 pages), Configuration Manual (34 pages), Configuration Manual (30 pages), Configuration Manual (30 pages)

Print Page

After first making a backup copy of the file, edit the /etc/fstab file. Add a line for each new

device to be mounted.

Example

#vi /etc/fstab

/dev/disk/dsk4a / ufs rw 1 1

/proc /proc procfs rw 0 0

/dev/disk/dsk12a /usr ufs rw 1 2

/dev/disk/dsk12b swap1 ufs rw 0 2

/dev/disk/dsk15c /HP5700_LU2c ufs rw 1 3

Table 4 Automatic mounting example explanation

Device

/dev/disk/dsk4a

/proc

/dev/disk/dsk12a

/dev/disk/dsk12b

/dev/disk/dsk15a

Notes: For UFS systems, you must File System Check (fsck) disks that contain mount points before

mounting other disks on those mount points.

Shut down and reboot the system.

Use the df or df –k command to verify file system auto mounting.

Checking path failover

The disk array supports Tru64 path failover (Tru64 v5.1B–2 and later only). You can connect multiple

FCAs to the disk array with shared LUNs. Confirm the existence of multiple paths for devices as follows:

Type hwmgr -view device to obtain the HWID for the device.

Type hwmgr -show scsi -full -id HWID to confirm the status of paths to the device.

If more than one path is currently connected, the status of each path shows as Valid. If you

change the cabling configuration, the old paths will show as Stale. Use the hwmgr -refresh

scsi command to remove the stale paths.

CAUTION:

Tru64 5.1B and later fully support dynamic load balancing and failover when multiple FCAs

are connected to the same LUN. This feature is ONLY available with version 5.1B and later.

Installing and configuring Tru64 for the XP disk array

Mnt Point

File system

ufs

/proc

procfs

/usr

ufs

swap1

ufs

/HP700_LU2c

ufs

Options

Backup (no=0,

(r/w)

yes=1)

fsck order