HP Xw460c - ProLiant - Blade Workstation Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Switch HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 2 pages. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
Also for HP Xw460c - ProLiant - Blade Workstation: Implementation Manual (35 pages), Error Prevention Manual (12 pages), Technical White Paper (12 pages), Firmware Update (9 pages), Installation Manual (2 pages), Frequently Asked Questions Manual (14 pages), Setup Poster (9 pages), Installation Manual (33 pages), Management Manual (28 pages), Hardware Manual (23 pages), Overview (35 pages), User Manual (33 pages), Optimization Manual (13 pages), Limited Warranty (10 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (8 pages), Installation Instructions (4 pages)

Print Page

Install the mezzanine card as shown below.

Or, for half-height server blades install as shown.

Reinstall the access panel.

NOTE: See the HP BladeSystem Enclosure Setup and

Installation Guide for more information on the

association between the mezzanine bay and the

interconnect bays. Where you install the mezzanine

card will determine where you need to install the

interconnect modules.

Restore the server blade to its operating position in the

server blade enclosure.

NOTE: By default, the server blade will power up on

installation.

Completing the installation

For information about installing and configuring drivers for

your specific operating system and mezzanine card refer to

the HP website

(http://www.hp.com/go/bladesystem/mezzanines).

European Union regulatory

notice

This product complies with the following EU Directives:

Low Voltage Directive 2006/95/EC

EMC Directive 2004/108/EC

Compliance with these directives implies conformity to

applicable harmonized European standards (European

Norms) which are listed on the EU Declaration of Conformity

issued by Hewlett-Packard for this product or product family.

This compliance is indicated by the following conformity

marking placed on the product:

This marking is valid for non-Telecom products and EU

harmonized Telecom products (e.g. Bluetooth).

This marking is valid for EU non-harmonized Telecom

products.

*Notified body number (used only if applicable—refer to the

product label)

Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140,

71034 Boeblingen, Germany

Korean class A notice