Diamond Products CC1600 Operator's Manual - Page 10

Browse online or download pdf Operator's Manual for Saw Diamond Products CC1600. Diamond Products CC1600 16 pages. Wall saw

Print Page

Ensure the saw is properly set up and ready for operation in accordance with

To prevent seal damage, do not operate the saw without sufficient water flow. The water

also assists in cooling the blade and carrying away cutting debris.

Two operating options are available: full manual, and power travel.

• FULL MANUAL – Open the inlet ball valve to start the blade rotation. Using the

15/16" socket and speed handle, turn the blade depth shaft to the desired cutting

depth. Feed the saw along the cut by turning the manual travel shaft with the

15/16" socket and speed handle. The pressure needed to drive the blade will

increase considerably when cutting steel, so resist forcing the saw and stalling the

blade. If the blade jams, back it up to free it. If this does not work, lift the blade

out of the cut until it starts turning again, then lower it back into the cut and

resume cutting.

• POWER TRAVEL USING STANDARD HYDRAULIC ASSEMBLY – Open the inlet

ball valve to start the blade rotation. Blade depth is set manually as above. To

feed the saw along the cut, set the flow control valve to "0". Shift the directional

valve in the direction you want to travel then, slowly turn the flow control valve-

adjusting knob until the desired speed is attained. Continue to adjust the flow

control knob as necessary to maintain desired speed.

•

POWER TRAVEL USING OPTIONAL HYDRAULIC ASSEMBLY – Open the inlet

ball valve to start the blade rotation. Blade depth is set manually as above. To

feed the saw along the cut, turn the adjusting knob counter-clockwise to the full

out position. Shift the directional lever in the direction you want to travel then,

slowly turn the adjusting knob clockwise until the desired speed is attained. If the

saw does not move, manual assistance using the speed handle may be required to

move the blade into the cut and build up enough back pressure to allow for saw

movement. Continue to adjust the control knob as necessary to maintain desired

speed. Feathering the directional lever toward the neutral position can attain some

speed control.

OPEARATING THE SAW

Never stand directly in line with a spinning blade. Severe

injury could result if a segment breaks off or the blade

Chapter 4

NOTE

Chapter 3 of this manual.

CAUTION

WARNING!

fractures.