Panasonic et-jpc100be Installation Instructions Manual - Page 13

Browse online or download pdf Installation Instructions Manual for Projector Panasonic et-jpc100be. Panasonic et-jpc100be 28 pages.

Print Page

Installation

The main procedures for using this product to install a projector (separately sold product) on a ceiling are as fol-

lows.

Before performing the work, be sure to shut off the power supply to the room by, for example, turning off the wir-

ing circuit breaker.

1) Preparing the adapter cover ( 13 page)

2) Mounting the ceiling mount bracket to the ceiling ( 13 page)

3) Connecting the indoor wiring for the power supply ( 17 page)

4) Changing the orientation of the main unit of the projector ( 18 page)

5) Mounting the projector mount bracket to the projector ( 19 page)

6) Mounting the projector to the ceiling mount bracket ( 21 page)

7) Connecting the power cord to the projector ( 23 page)

8) Adjusting the projection position ( 25 page)

String attachment hole

Check the height, space, and structure of the installation location and then determine the installation position on

the ceiling in advance while referring to "Installation position" ( 10 page). Use the center of the projector pole as a

guide for positioning.

The mounting method for the ceiling mount bracket differs depending on the structure of the ceiling. Install it in a

way that is appropriate for the ceiling to which it is to be mounted.

Check that the installation location of the ceiling mount bolts and ceiling kit is strong enough to withstand the

weight of both the projector and ceiling kit.

Attention

 When mounting the product to the ceiling with ceiling mount bolts, be sure to use commercially available

ceiling mount bolts, hexagonal nuts, ﬂ at washers, spring washers, and anchor nuts or curled plugs for the

M10 thread size.

 When mounting the product to a concrete ceiling with ceiling mount bolts, drill anchor nut or curled plug

mounting holes to match the size speciﬁ ed by the manufacturer.

 Securely tighten each nut, and if necessary take a measure such as using two nuts

or thread-locking ﬂ uid to prevent loosening.

 When mounting the product to a ceiling with wood screws, ensure there will be

thread engagement of at least 16 mm (5/8") in the ceiling reinforcement member and

purchase wood screws with a nominal diameter of 3.1 mm (1/8").

1) Attach the string to the adapter cover.

 Pass the end of the string (end with the small loop)

through the hole in the adapter cover and then

attach the string to the adapter cover as shown in

the following diagram.

Two nuts

ENGLISH - 13