Panasonic PT-L735NTE Operating Instructions Manual - Page 24
Browse online or download pdf Operating Instructions Manual for Projector Panasonic PT-L735NTE. Panasonic PT-L735NTE 34 pages. Commercial use
Print Page
RGB/YP
P
B
R
This setting is valid when 750p,
HDTV60, HDTV50, 525p, 625i and
525i signals are being input. Select
the setting in accordance with the
input signal.
The RGB/YP
P
item is displayed
B
R
when the RGB1 IN or RGB2 IN
connector has a signal being input.
VGA60/525P
When a VGA60 or 525p RGB signal
is being input, select the signal in
accordance with the input signal.
BLACKBOARD
Set to "ON" when PICTURE MODE
is set to BLACKBOARD. (Refer to
page 37.)
BACK COLOR
This sets the colour which is
projected onto the screen when no
signal is being input to the projector.
FRONT/REAR
This setting should be changed in
accordance with the projector
setting-up method.
Set to "FRONT" when using a
normal reflective screen with the
projector positioned in front of the
screen, and set to "REAR" when
using a translucent screen with the
projector positioned behind the
screen.
DESK/CEILING
This setting should be changed in
accordance with the projector
setting-up method.
Set to "DESK" when setting up the
projector on a desk or similar, and
set to "CEILING" when suspending
the projector from the ceiling using
the ceiling bracket which is sold
separately.
46-E
NGLISH
FAN CONTROL
Set FAN CONTROL to "HIGH",
when using this projector at high
elevations (above 1 400 m) only.
LAMP POWER
This setting changes the lamp
brightness. When set to "LOW", the
luminance of the lamp is reduced, but
the projector uses less power, and
the operating noise is also reduced.
This can help to extend the lamp's
operating life. If using the projector in
small rooms where high luminance is
not required, it is recommended that
you set the LAMP POWER to "LOW".
LAMP RUN TIME
This setting displays the usage time
for the lamp unit which is currently
being used.
NOTE:
B The lamp's operating life varies
depending on the usage
conditions (such as the LAMP
POWER setting and the number
of times the power is turned on
and off).
FUNC 1
This assigns a function to the FUNC1
button of the remote control unit .
MUTE
Functions in the same way as the
MUTE function. (page 44)
KEYSTONE
Functions in the same way as when
"KEYSTONE" is selected from the
POSITION menu screen. (page 41)
CONTROL KEY
To disable the buttons on the
projector, set CONTROL KEY to
"OFF". A confirmation screen will
then be displayed. Select "OK" by
using I and H buttons. To use the
buttons on the projector, set to "ON"
by using the remote control unit.
AUTO POWER OFF
If any signal is not input into the
projector during the time that you set
up, the projector will return to standby
mode. The auto power off time can
be set to, from 15 minutes to 60
minutes, by 5 minutes. If you don't
use this feature, set it to "DISABLE".
This feature will not function under
the following situation.
1) When using the freeze function.
2) When the NETWORK or SD
CARD is selected (PT-L735NTE
only).
3) When writing the data in the SD
memory card (PT-L735NTE
only).
NOTE:
(PT-L735NTE only)
B When the projector is connected
to a personal computer by
means of the wireless network
using the accessory wireless
card, the projector will go in the
WEB STANDBY. (page 48)
E
-47
NGLISH