Diamondback 180 Installation Manual - Page 2

Browse online or download pdf Installation Manual for Automobile Accessories Diamondback 180. Diamondback 180 2 pages. For toyota tacoma 2005; toyota tacoma 2006; toyota tacoma 2007; toyota tacoma 2008; toyota tacoma 2009; toyota tacoma 2010; toyota tacoma 2011; toyota tacoma 2012; toyota tacoma 2013; toyota tacoma 2014; toyota tacoma 2015; toyota tacoma 2016; toyota taco
Also for Diamondback 180: Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages)

ADJUST THE LOCK RODS
Use an 1/8" hex key to loosen the
8
set screws on the linkages of the
driver-side lock rods.
Adjust the length of the lock rods and retighten the set screws so that:
9
A. with the lock handle in the open position, the rod tips clear the
angle iron (forward) and the T-panel gutter (rearward),
B. with the handle in the closed position, the forward rod tip does
not strike the bulkhead, and
C. the rods point downward.
ATTACH THE GAS SPRINGS
Attach the gas springs to the ball studs.
13
To avoid premature failure of your gas
springs, attach them barrel up, shaft down.
Leave the cover closed and locked
14
for 24 hours to allow the weather-
strip adhesive, which is pres-
sure-sensitive, to fully cure.
WWW.DIAMONDBACKCOVERS.COM
1/8 " Hex Key
Position the lock rods tight
10
against the underside of the
angle iron (forward) and T-panel
gutter (rearward) so that they
draw the panels down and
compress the perimeter
weatherstrip. Tighten
the rod guide
brackets with a
7/16" socket.
Repeat steps 8–10 for the passenger-side lock rods.
11
Double-check both panels to ensure they open, close, lock and seal
12
correctly. If at any point the weatherstrip does not touch the bed rails,
readjust the lock rods and mounting brackets as needed.
To ensure the best weatherstrip adhesion, leave your
cover and tailgate closed for 24 hours after you've
made your final adjustments.
Operating the access panels is easiest when
you press down as you open or close them.
7/16" socket
MARCH 2016