Panasonic SA-AKX910 Operating Instructions Manual - Page 11
Browse online or download pdf Operating Instructions Manual for Stereo System Panasonic SA-AKX910. Panasonic SA-AKX910 40 pages.
Print Page
Checking the signal status
When "FM" is selected
Press [DISPLAY].
FM – – – –
The FM signal is weak.
The system is not tuned in to a station.
FM ST
The FM signal is in stereo.
FM MONO
"MONO" is selected as the "FM MODE".
The FM signal is in monaural.
AM allocation setting
This system can also receive AM broadcasts allocated in
10 kHz steps.
When "AM" is selected
Press and hold [SELECT].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps again.
• Preset frequencies are erased after you change the
setting.
Recording
This system can record up to 800 folders (maximum 999
tracks in an album) or a total of 8000 tracks, depending on
the available storage capacity of the internal memory or
the USB device in
.
USB B
To check storage space
In the stop mode, press [DISPLAY] repeatedly.
Example: Remaining recording time of the internal memory.
Internal memory
source
• "UPDATE" is shown when the system is reading the
USB device.
• "NO DEVICE" is shown if there is no USB device
connected to
.
USB B
To select where recordings are kept
1
Press [SETUP] repeatedly to select "REC TO?".
2
Press [Y, U] to select "MEMORY" or "USB B" and
then press [OK].
Remaining
recording time
Note:
•
All recordings are in ".mp3" format.
•
You cannot do recording when you are using random
playback mode.
•
The DJ function or Karaoke function is switched off when
you start recording.
•
Repeat playback mode is cancelled during recording.
•
A new album is added each time you do a recording.
•
The sequence of album may change after the recording.
•
The recordings are kept in a folder named "REC_DATA" in
the USB device or the internal memory.
•
USB status indicator blinks in red during USB recording.
Basic recording
1
Select the source you want to record.
CD-DA
Prepare the disc playback mode.
Record all
Select "OFF PLAYMODE" (~9).
tracks
Record a
Select "1-TRACK" (~9).
specified track
Make sure the disc is stopped.
Radio
Tune in to the radio station.
AUX
Connect and play the equipment (~16).
2
Press [REC 7/9] to start recording.
The name of the folder that keeps the recording is
shown.
Stop recording
Press [8]. "WRITING" is shown.
Pause
Press [REC 7/9] during recording.
recording
Press again to continue recording.
Note:
You can pause during recording from the
radio, AUX (except in "SYNCHRO" mode).
A track mark is added every time you
~12
pause (
Note:
•
Wait for a few seconds for the system to prepare the USB
device before you start recording.
•
When the next track of the disc is being recorded, it will be
shown on the display.
█ High-speed recording
CD-DA disc recording speed:
CD, CD-R: Three times (3x) the normal speed.
CD-RW: Two times (2x) the normal speed.
1
Put in the disc you want to record.
2
Press [REC MODE] repeatedly to select "NORMAL"
or "HI-SPEED" and then press [OK].
3
Press [REC 7/9] to start recording.
Note:
•
If you cannot record at high-speed because of the condition
of the disc, record at normal speed.
•
The sound is muted during high-speed recording.
).
11
11