Panasonic SCPM53 - HES MICRO SYSTEM Operating Instructions Manual - Page 5

Browse online or download pdf Operating Instructions Manual for Stereo System Panasonic SCPM53 - HES MICRO SYSTEM. Panasonic SCPM53 - HES MICRO SYSTEM 16 pages. Panasonic cd stereo system operating instructions
Also for Panasonic SCPM53 - HES MICRO SYSTEM: Operating Instructions Manual (24 pages), Operating Instructions Manual (16 pages)

Print Page
Panasonic SCPM53 - HES MICRO SYSTEM Operating Instructions Manual
Optional antenna connections
Optional antenna connections
FM outdoor antenna
T
F M A N
7 5
(Only for the U.K.)
Use the antenna
plug adaptor
(included).
• Never use an outdoor antenna during a lightning storm.
• You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
• Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
• Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire horizontally
along a window or other convenient location.
Step 2
Step 2
- Inserting batteries into the remote control
- Inserting batteries into the remote control
AA/R6/LR6
S S tep 3
tep 3
- DEMO function
- DEMO function
RQTV0102_2B.indd 5
RQTV0102_2B.indd 5
FM outdoor antenna
(not included)
75 Ω
coaxial cable
(not included)
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of
time. Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fi re.
Do not:
• mix old and new batteries.
• use different types of batteries at the same time.
• heat or expose to fl ame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if their covering has been peeled off.
■ Use
• Aim at the remote control sensor, avoiding obstacles, at a maximum
range of 7 m directly in front of the unit.
Refer to page 6 for remote control signal sensor position.
When the unit is fi rst plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [–DEMO, 7].
The display changes each time the button is held down.
DEMO OFF
While in standby mode, select "DEMO OFF" to reduce power
consumption.
AM outdoor antenna
AM outdoor antenna
T
F M A N
(not included)
7 5
DEMO ON
AM loop antenna
(included)
2/9/07 11:14:19 AM
2/9/07 11:14:19 AM
5