Panasonic SG-1030L Service Manual - Page 2

Browse online or download pdf Service Manual for Stereo System Panasonic SG-1030L. Panasonic SG-1030L 15 pages. Fm/am/fm stereo radio with cassette tape deck and record player

Print Page
DISASSEMBLY INSTRUCTIONS |
Remove Record Player (To Replace Components)
a
To
Remove
belt
1. Remove T.T. mat.
2. Remove belt from the motor pulley. (Fig. 1)
3. Remove two (2) bottom board mounting screws and unplug 5P
~connector plug from chassis.
(Fig. 3)
4. Remove five (5) bottom cover mounting screws.
(Fig. 3)
5. To reassemble reverse above procedure.
= To Remove
Escutcheon from Chassis |
Remove five (5) knobs from escutcheon assembly.
Remove seven (7) escutcheon assembly mounting screws (Fig. 3, 4)
To reassemble
reverse above procedure.
:
= To Remove
Cassette Deck
|
. Push EJECT button to open cassette lid.
. Remove cassetie lid by sliding while holding the rear side in the
direction of arrow. (Fig. 2)
_ —
|
. Remove two (2) cassette cover mounting screws.
(Fig. 5)
. Remove four (4) cassette cover mounting screws.
(Fig. 3)
. Remove four (4) cassette deck mounting screws.
(Fig. 6)
Escutcheon
Mounting
Cassette Cover Mounting
Screws (XTV3-+ 10B)
Screws (XTV3-+ 10FNK)
a
HR.
j
mS
TS
=
N
—
Mm orf
&
SCI.
OMEN 26s
os
XVOD. B a
Escutcheon
Mounting Screws
(XTW3-+
1OFNK)
s To Replace Cartridge
1. To remove cartridge, push it in direction of arrow A, as shown in
a! x
Pickup Arm
FIGs 7:
|
WY
Cartridge
2. Toinstall cartridge, push it in the direction of arrow B, as shown in
|
PIGs 7:
7
3. Disconnect four (4) connectors from cartridge terminals gently.
4. Fit the new one.
(When installing wires, make sure they are fitted
correctly on their proper positions onto connectors.)
|
5. The
cartridge
should
be perpendicular
with the head
shell
(pickup) and it should be installed straight upward, observing that
its edge is in line with the head shell.
_@ To Replace Stylus
1. Lift pickup arm to a position that will make the stylus accessible.
(Fig. 8)
|
2. Gently pull out worn stylus and replace new stylus into correct
position.
(Fig. 8)
~ $G-1030L
|