Biomorph SX5M-BAA-FF-C-B-DSDS Manual - Page 13

Browse online or download pdf Manual for Indoor Furnishing Biomorph SX5M-BAA-FF-C-B-DSDS. Biomorph SX5M-BAA-FF-C-B-DSDS 15 pages.

Print Page

Cable Diagram

IMPORTANT:

All cables must be tacked up and made neat with supplied cable guides. NO cables may hang down ex-

cept those passing through cable chains. Make sure cables have enough slack between surfaces to allow

full height adjustment between surfaces.

IMPORTANT:

Extend desktops to full opposite heights to ensure that cables will travel w/o stress).

CABLE CAB

(Optional) Place door towards user.

SHORT CABLES

Use SHORT cables to connect 3 rear legs

to ports #1, #2 & #3 in controller box.

3 PORT CONTROLLER

box for REAR surface

LONG CABLE/

FRONT LEG

POWER CABLE

Connect power cables to power

strips inside cable cabs.

CABLE CHAIN

Use to run cables from front surface

to rear surface. Push in from inside.

SWITCH

for REAR surface use long 45˚ angle bracket.

Control switches connect to port A1.

2 PORT CONTROLLER

box for FRONT surface

LONG CABLE/

FRONT LEG

POWER CABLE

SWITCH

LONG CABLE/FRONT LEG

SHORT CABLE/REAR LEG

CABLE TRACKS

Red FRONT surface

Blue REAR surface

LONG CABLES

SWITCH

Use LONG cables to connect both front

LONG CABLE/

legs to ports #1 & #2 in 2 Port Controller box.

FRONT LEG

SWITCH

for FRONT surface use long 45˚ angle bracket.

Control switches connect to port A1.

GROMMET HOLE

Place grommet into

grommet hole. Route

cable accordingly.

WIRE CLIP

A wire clip MUST be placed directly

behind switch to prevent cable droop