HTC DESIRE 526G Safety And Regulatory Manual - Page 8

Browse online or download pdf Safety And Regulatory Manual for Cell Phone HTC DESIRE 526G. HTC DESIRE 526G 30 pages.
Also for HTC DESIRE 526G: User Manual (10 pages), User Manual (10 pages)

Print Page

 Electrostatic discharge (ESD)

Do not touch the SIM card's metal connectors.

 Emergency calls

This phone, like any wireless phone, operates using radio signals,

which cannot guarantee connection in all conditions. Therefore,

you must never rely solely on any wireless phone for emergency

communications.

Regulatory agency identifications

For regulatory identification purposes, your product is assigned a

model number of 0PL4200.

Your phone's FCC ID is NM80PL4200. This FCC ID can also be

found printed inside the battery compartment.

To ensure continued reliable and safe operation of your device use

only the HTC qualified battery with your Desire 526G: Battery Pack,

model number B0PL4100.

Operating temperature range: 32°F to 104°F (0°C to 40°C)

NOTE: This product is intended for use with a certified Class 2

Limited Power Source, rated 5 Volts DC, maximum 1 Amp power

supply unit.

Federal Communication Commission Interference

Statement

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the

following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

 Consult the dealer or an experienced radio or television

Safety and regulatory guide 8