EasyPro Eco-Clear EPS4900 Instructions For Operation, Safety, Warranty - Page 4

Browse online or download pdf Instructions For Operation, Safety, Warranty for Pond Pumps EasyPro Eco-Clear EPS4900. EasyPro Eco-Clear EPS4900 8 pages. Submersible pond pump

Print Page

The top housing is also connected at the handle.

This can be a little tricky to release. Slightly lift the

front of the housing and push the top of the handle

to release the housing.

Clean out any debris inside the housing.

It may be easier to remove adjustable ball joint at

this point, but access to the impeller can be made

with it attached. To remove the adjustable ball

assembly, loosen the blue nut from the pump.

With a Phillips screwdriver remove the four screws

and two brackets that secure pump body to lower

housing. Be sure not to lose any screws during

disassembly.

Remove the screw holding the power cord strain

relief clip.

To access the impeller assembly, remove four

screws from pump impeller housing.

10.

Carefully pull the impeller out of its chamber.

11.

Inspect and clean the impeller and chamber. Clean

the impeller and chamber using water and a damp

cloth or sponge. A vinegar mixture may help remove

hard deposits. If the impeller is damaged, replace

with a new impeller.

12.

Once the impeller is cleaned or replaced with new

one, reverse the steps to reassemble the pump and

housing.

Tip To attach the top housing, start by securing the

latch at the handle first. Align the top and bottom

housing sections and squeeze them together at the

handle to latch them in place. Then secure the four

clips.

13.

Reattach the plumbing and return the pump back to

the pond. Plug the pump back in and observe the

operation to make sure it is working properly.

Step 4

Step 7

Step 8

Step 10

Step 12