EasyPro EP1750 Instructions For Operation, Safety, Warranty

Browse online or download pdf Instructions For Operation, Safety, Warranty for Pond Pumps EasyPro EP1750. EasyPro EP1750 4 pages.

Print Page

EP120 • EP200 • EP400 • EP600 • EP850

EP1050 • EP1350 • EP1750 • EP2200 • EP3200N

Thank you for purchasing the EasyPro Mag Drive pump.

This pump is a magnetically driven water pump. It contains no

oil, rotating shafts, shaft seals or bearings. This pump combines

simplicity of design with the most energy efficient operation of

any pump. All electrical components are encapsulated in epoxy.

The impeller assembly consists of impeller blades attached to a

magnet and is easily replaced should the need arise. There are

threaded discharge and intake ports on all models.

Safety & Electrical Connections

Always disconnect the electrical supply before handling, maintaining, repairing or installing any

pond equipment.

Connect this product only to a 110 volt receptacle that is protected by a Ground Fault Circuit Interrupter

(GFCI).

The pump must be fully submersed underwater at all times when operating.

Never let the pump run dry, as this can damage the impeller, over heat the pump and possibly burn out

the pump.

Do not use this product in bathrooms or swimming pools.

All electrical work must be performed by a qualified technician. Always follow the National Electrical

Code (NEC) or the Canadian Electrical Code as well as all local, state and provincial codes. Code

questions should be directed to your local electrical inspector. Failure to follow electrical codes

and OSHA safety standards may result in personal injury or equipment damage. Failure to follow

manufacturer's installation instructions may result in electrical shock, fire hazard, personal injury or

death, damaged equipment, provide unsatisfactory performance, and may void manufacturer's warranty.

When installing fittings into the pump, do not overtighten as this could crack the housing and void

the warranty.

Do not remove the pre-filter or the pre-filter cover from the pump as this will cause excess debris to

enter the pump and may void the warranty.

Troubleshooting:

If the pump fails to operate, please check the following before contacting EasyPro:

Note: Always disconnect from electrical outlet before handling the pump.

Check the GFCI circuit breaker or try another GFCI electrical outlet to ensure the pump is getting power.

Check the tubing for kinks and obstructions. Check filter cover and foam filter for blockage. Follow

cleaning steps in the maintenance section if blockage is suspected.

If necessary, remove and clean the impeller assembly.

Mag Drive Pumps

Instructions for Operation • Safety • Warranty

Components included with EP1350, fountains may vary