HTC 400 DS User Manual - Page 24

Browse online or download pdf User Manual for Floor Machine HTC 400 DS. HTC 400 DS 38 pages.

Operation

4.3. Access to grinding tools

Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
1.
2.

4.4. Fitting and replacing grinding tools

Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.

4.4.1. Fitting grinding tools

1.
16
Set the handle to the rear position - see Figure
4-1 on page 15.
Tip the machine backwards so that it rests against the
ground.
Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder. Then push the
tool fully into the guide slot, see Figure 4-2 on page 17.
HTC 400 DS
2.0