Bionaire BCH9222-CN Instruction Leaflet - Page 5

Browse online or download pdf Instruction Leaflet for Heater Bionaire BCH9222-CN. Bionaire BCH9222-CN 11 pages. With advanced touchscreen control

Print Page

F E AT U R E S - O P E R AT I O N S

Mode Selection

Select your desired heat settings by a finger touch onto the

corresponding icons as located on the Touchscreen of your

heater or press the Mode button on remote control to cycle

through the heat settings.

Fan Only Setting

Press the Fan Only icon to run the heater without heat

output.

Figure 7

CONTROL PANEL

LCD Display

Touchscreen icons

Remote Control

– HIGH Heat Setting

Press the Max icon to run the heater at maximum setting (at

1500W) and the Stay On icon will illuminate on the LCD

Display.

– Heat & $ave™ Setting

Press the Heat & $ave™ icon to activate the energy

efficient Heat & $ave™ Mode. The heater will now cycle

between high (at 1500W) and low (at 750W) heat settings to

provide heat.

Programmable Thermostat

You may set your heater to a precise comfort level (from

30°C to 18°C) while you are in any of the above modes by

simply pressing the up or down arrow icons on the control

panel or on the remote control. This will deactivate the

current mode and switch the heater into Thermostat mode.

You can adjust the desired temperature in 1° increments

from 30°C to 18°C. The LCD display will show the selected

temperature reading. When the preset temperature is

reached, the heater will shut off and cool down for at least

15 seconds. When the room temperature drops below the

preset temperature, the heater will automatically turn on

again to maintain the preset temperature level.

FrostProtect™ Setting

Your heater is equipped with FrostProtect™ feature. The

heater will turn on automatically when the room temperature

drops below 5°C. To activate FrostProtect™ feature, press the

arrow icons to show temperature reading "5" then the

FrostProtect™ icon ( ) will appear on the LCD Display.

NOTE: It is normal for the heater to cycle on and off to

maintain the preset temperature. Raise the thermostat setting

to prevent the heater from cycling. When the preset

temperature is reached or when the heater is shut off, the fan

will run for 15 seconds without heat. This cool down process

ensures an accurate and consistent temperature reading.

NOTE: The timer does not work with the FrostProtect

setting.

NOTE: To shut the heater off at any setting, press the Power

icon (

) until the temperature reading goes off. The Power

icon and clock time will remain illuminated until heater is

unplugged. The heater will cool down for at least 15 seconds.

The digital thermostat has memory; it will remember the last