HTC GL 270 HD User Manual - Page 14

Browse online or download pdf User Manual for Floor Machine HTC GL 270 HD. HTC GL 270 HD 42 pages.

Print Page
Safety
Warning!
During grinding, the tools become very hot. Tip the machine back and allow it
to stand for a short while. Use protective gloves when removing the tools.
Warning!
Disconnect the electrical supply when cleaning, changing tools or repairing the
machine.
Warning!
The machine may only be used and moved on horizontal surfaces. There is a
risk of crush injuries if the machine starts to roll.
Warning!
Do not clean the machine using a high-pressure washer. Otherwise, moisture
may penetrate electrical elements and damage the machine's drive system.
Warning!
Always ensure that the machine's connection cable is hanging freely without
any tensile loading. Otherwise, the cable, coupling socket and plug may be
damaged, which can cause both physical damage and personal injury.
Warning!
Always ensure that the machine's handle is in the upright position when the
machine is tipped to enable access beneath the grinding head. Otherwise, there
is a risk that the machine could fall back and cause personal injury.
Warning!
The lifting handles on the motor are intended for lifting the grinding head,
when it is separated from the chassis, and then only for short, low lifts, e.g. into
the boot of a car. The lifting handles are not to be used for lifting the complete
machine.
Warning!
When working on an elevated surface where there is a risk of falling, the edges
of the surface must be secured. The values for the machine's thrust and load
capacity as well as the driving speed are given in the table for the machine's
technical data in the chapter "Technical Data".
2.3

Notes

Note!
The machine must be connected to an earth fault breaker suitable for electronic
frequency convertor operation.
6
HTC GL 270 HD
2.0