EasyPro Spirit TLS2750 Instructions For Operation Manual - Page 4

Browse online or download pdf Instructions For Operation Manual for Pond Pumps EasyPro Spirit TLS2750. EasyPro Spirit TLS2750 6 pages. Pond & stream pump

Print Page

Trouble Shooting

Before taking any trouble shooting action, disconnect pump from the

power supply. If there is any damage to the power cord or pump, repairs

or replacements must be handled by EasyPro or a qualified party.

Does not start

Does not shut-off • Pump is not disabled by float (not included),

Humming

Running, no water • Suction grid or piping are clogged

Running, very

little water

GFCI breaker

tripping

Motor briefly

starts and stops

Pumps stops

• Make sure power cord is plugged in

• Float (not included) may not be moving

freely, increase depth

make sure float can move freely

• Line circuit breaker is off, fuse is burned or loose

• Pump cord is not making contact in receptacle

• Impeller is worn or stuck

• Required head is too high for the pump specifications

• Water level is too low

• Pump is air-locked, start and stop several times by

plugging and unplugging cord, check for clogged

vent hole

• Vertical pumping distance is too high or the pipe

size is too small

• Inlet or impeller clogged

• Low water conditions with pump sucking air

• Mechanical seals may need to be replaced

• Power cord may be damaged and getting wet

• Nuisance trip due to improper grounding

• Overloaded circuit

• Low water conditions, pump overheating

• Inlet or impeller clogged

• Improper power supply

• Make sure water being pumped is not too dense,

causing the pump to overheat.

• Clear obstructions on impeller

• Check power supply to comply with nameplate data

• Wait for pump to cool, correct reason for overheating,

plug back in and resume operation