EasyPro Vianti Falls Installation Manual - Page 2

Browse online or download pdf Installation Manual for Outdoor Fountain EasyPro Vianti Falls. EasyPro Vianti Falls 4 pages.

Print Page

Determine the placement

of the Vianti Falls system.

Prepare the base for the

48" half basin by properly

compacting and leveling the

area. The Vianti Falls spillway

is designed to be placed

approximately 12" to 30"

above the basin. The center

of the spillway and the basin

must be aligned. The spillway

must be positioned in the wall

to allow for the lip to protrude

past the wall 1

" (assuming

the wall is plumb). This is to

ensure water will land in the 6"

x 39" splash mat included with the basin. Extended lip kits

come with 14" x 39" additional splash mat to be installed

on top of basin (see page one).

When building the

block wall, a section

of wall must be left out to

accommodate the plumbing

and electrical cord for the

pump. The notch in the back

of the basin is for the power

cord of the pump. If an auto

fill line is being installed a

section of wall should also

be open to accommodate

the auto fill feed line.

Once the spillway

placement has been

determined in the block wall,

the block will need to be cut

to allow for the plumbing

connections on the back of

the spillway. Use appropriate

tools and extreme care when

cutting block. Consult block

manufacturer recommendations

for properly cutting block

being used.

If the lighting option is purchased the LED light strip

can be fitted into the back of the spillway. There are

brackets on the ends of the light bars with holes in them.

These brackets are for other applications. The LED light

bar should fit snuggly into the back of the spillway.

If necessary, a small amount of silicone can be used as an

adhesive to

hold the bar

in place.

Splash

Mat

Power

Cord

Notch

Hole for

Plumbing

and Pump

Power Cord

Depending on the look

desired, the block that

goes around the spillway

may need to be cut to

ensure proper leveling and

look of the spillway in the

wall. The type of block

being used will determine

the method used. A lentil

may be required for longer

spillways or in walls that

would require additional

weight bearing support. Consult a qualified professional

for specific installation requirements and codes.

The spillway should be "dry fit" to ensure the spillway is

level from side to side and front to back.

Once the spillway is

level and "dry fit" the

plumbing can now be

fitted. Use the1" PVC male

adaptor and the fittings

provided to connect

spillway to the flexible PVC

pipe. Wrap the threads

of the PVC male adaptor

with Teflon tape and thread

into the spillway inlet(s).

Determine the placement of additional fittings (elbows,

tees, and extra pipe). Cut and glue all the pieces together

to fit the application.

The dual inlet units can be supplied with one mainline.

Picture is for illustration only. Application may vary

from image shown. After the mainline is split into two, the

plumbing lengths to the spillway inlets should be equal.

This will ensure equal flow rates to both inlets, while being

able to control the overall flow with a single ball valve.

The cord for the LED light

strip can be tucked into

the notch in the spillway.

A dab of silicone should be

used to seal the notch on

opposing side. Tuck the cord

between the blocks to run

the cord to the power source.

Ideally, run cord through

conduit for future maintenance or removal of light strip.