EasyPro EC1300U Instructions For Operation, Safety, Warranty - Page 5

Browse online or download pdf Instructions For Operation, Safety, Warranty for Water Filtration Systems EasyPro EC1300U. EasyPro EC1300U 8 pages. Eco-clear pressurized filters

Print Page

UV Lamp and Quartz Sleeve Replacement – EC1300U

For units with UV lights it is recommended that a new lamp be installed after 12 months of

use. While the light might still turn on, the effectiveness of the UV light diminishes over time.

A glow from the clear section on the top indicates that the UV light is in use. Quartz sleeves

are typically long lasting and only require replacement if they break or develop a leak due to

the age of the seals.

UV Lamp Replacement

1. Unplug the UV unit and the pump.

2. Remove the six screws from around the top of the filter.

Take care not to lose any of the screws during this

process.

3. Remove the circular retaining ring and the top cover.

4. Remove the two screws and the plastic retainer clip that

holds the cord in place.

5. Unscrew the clear plastic UV lamp connector nut and

carefully remove from housing.

6. Remove the old UV lamp.

7. Carefully remove the black stabilizing protector on the end

of the bulb.

8. Do not touch the new bulb with your fingers. The oil from

your skin can cause pre-mature failure of the lamp.

9. Hold the new 9 watt lamp with a glove or clean cloth and

plug into the UV housing. Transfer the black stabilizing

protector unit to the new lamp.

10. Carefully slide the new lamp into the sleeve and screw

the connector back into place.

11. Reattach the cord retainer clip with the two screws.

12. Line up the cord properly in the housing and replace the

top cover and circular retaining ring. Secure with the six

screws.

13. Return the unit back to service.

UV Quartz Sleeve Replacement

1. Unplug the UV unit and the pump.

2. Loosen the locking nut that secures the outlet tubing

connector to the filter and remove it from the lid. Be sure

not to lose the gaskets that seal the connector to the

filter.

3. Remove the six screws from around the top of the filter.

Take care not to lose any of the screws during this

process.

4. Remove the circular retaining ring and the top cover.

Step 2

Step 4

Step 5

Step 9