Bionaire BD10S-CN Instruction Leaflet - Page 6
Browse online or download pdf Instruction Leaflet for Dehumidifier Bionaire BD10S-CN. Bionaire BD10S-CN 8 pages. Digital dehumidifier
Print Page
Trouble
• Dehumidifier
shuts off
automatically.
• Signal with 3 long
beep sounds
followed by 2
short ones, and
then the
dehumidifier
automatically
shuts off.
• EO Code on
Display.
• Appliance cycles
on/off.
• Warm air coming
from outlet grill.
If you have any questions regarding your product or would like to learn more about other Bionaire
contact our Consumer Service Department at 1-800-253-2764 or visit our website at www.bionairecanada.com.
T R O U B L E S H O O T I N G
TROUBLESHOOTING
Probable Cause
☛ Reservoir is full.
☛ The compressor starts to
malfunction during the operation.
☛ The unit's sensor detects the room
temperature is below 0 °C or
above 40 °C.
☛ The sensor malfunctions.
☛ This is normal operation when
using the automatic
dehumidification setting. The
humidistat within the appliance
adjusts to maintain your desired
comfort level. To run continuously,
select the continuous mode (see
operating instructions).
☛ Heat exchange while the
compressor is on.
Solution
✔ Follow Water Full Protection & Auto-Shutoff
instructions in this manual.
✔ Wait for 3 minutes and then restart the unit
again. If you wish to restart the unit without
waiting for 3 minutes, unplug it from the
electrical outlet and plug it again.
✔ Wait until room temperature is within safe
operating temperature (0-40 °C).
✔ Relocate your dehumidifier to another room
and operate normally. To restart the unit it
will be necessary to unplug it from the
electrical outlet and plug it back in.
✔ Restart the unit after troubleshooting.
✔ This is normal operation.
✔ This is normal operation.
products, please
®