Dickinson Radex 1 Operator's Manual - Page 3
Browse online or download pdf Operator's Manual for Heater Dickinson Radex 1. Dickinson Radex 1 9 pages.
Print Page
A
Radex 1
10.38" /
26.37cm
Radex 2
16.88" /
42.88cm
VOLTS
Radex 1
Radex 2
Note: 24 volt motors may be in stock depending on inventory stock
Your Radex Heater
Thank you for choosing the Radex water to air heat exchanger. The Radex heater is designed
to efficiently use the waste water heat produced by a water cooled engine or a hot water boiler
system, to generate a source of forced air heat. The Radex is suitable for use in boats, RVs,
trucks, cars and anywhere else a source of circulating hot water and 12v power is available.
There are two Radex models, the Radex 1 and the larger Radex 2. Each use a very quiet,
low amp draw fan to push air through the heated coil to heat a space.
Mounting Kits
Two mounting kits are available for the Radex 1 and Radex 2.
Side mount bracket kit 22-001 fits both the large and the small Radex and is used to
mount the Radex to the floor, a wall or ceiling. The frame mount kit (22-002 for Radex 1
and 22-003 for Radex 2) is used to install a recessed Radex flush in a bulkhead or cabinet
with a trim panel.
www.dickinsonmarine.com
B
C
7.00" /
5.00" /
17.78cm
12.7cm
7.00" /
5.00" /
17.78cm
12.7cm
AMPS
12
0.74
12
1.48
~
Form# 7.2-63 (2)
D
E
2.00" /
12.38" /
5.08cm
31.45cm
2.00" /
18.00" /
5.08cm
45.72cm
CFM
BTU/HR -
KW
100
12000/
3.5kW
200
24000/ 7 kW
F
3.00" /
7.62cm
3.00" /
7.62cm
WEIGHT
6.5lbs / 3kg
9lbs / 4kg