dicodes Dani Box Micro Manual - Page 9

Browse online or download pdf Manual for Electronic Cigarettes dicodes Dani Box Micro. dicodes Dani Box Micro 18 pages.

Print Page

05 Main Menu (Page 5)

The mod can be used in up to 5 operation modes. The mode can be selected in this menu:

The default operation is either power (0) or temperature controlled vaping (1).

With the "Expert Mode" (Extended Functions Mod-Menu) enabled, additional operation modes are

Heater Protection (2), P

With Expert Mode disabled, the menu options 2..4 are masked out.

For example, with a coil resistance of 2 Ohms and a power setting of 80W, the required voltage at the coil

is 12.6V. So with 2 Ohms the maximum wattage is 60.5W ((11V)²/2R=60.5W).

Or, if the coil resistance is 0.1 Ohm the maximum power is 48.4W, because (22A)²*0.1Ohm=48.4W.

As can be seen from the examples, with high coil resistance the power is limited by the maximum voltage

of 11V and with low resistances by the maximum current of 22A. The fact is also reflected in the feature

list: A power of 80W is guaranteed from 0.17 to 1.5 Ohms. (Resistances of 0.05 to 5 Ohms are possible,

but with a reduced power).

For commonly used wires, the predefined coefficents are: NiFe30=320, Nickel200=620, Titanium=350,

SS304=105, SS316=88, SS316L=92 and NiFe48=480. Note that there are different alloys for Titanium

and Stainless Steel on the market, so the predefined values can deviate from the actual wire-value you use.

In these cases it is preferable to choose "Other" as the wire type and set the value of the wire in the

extended functions heater menu "TempCof". The range for the coefficient is 050 to 650.

If you use the dicodes wire (RESISTHERM) it is guaranteed that the wire will always have the same

coefficient, because the wire was especially designed for temperature regulation purposes. The regulation

accuracy is best then, as the combination of resistivity and high coefficient is very good.

Note for using Nickel wire: Nickel has a high and always precise temperature coefficient (Ni200). But

Nickel is not so easy to handle, because it is quite soft and it leads to very low resistance coils, because

of it's high conductivity. For the regulation accuracy smallest changes of contact resistances due to atomizer

movements (tightening) or mechanical thermal elongations lead to poor regulation accuracy.

Heater Control (Operation modes)

ower Boost (3),

and Bypass (4, mechanical mod).

0. Power Mode

In the power operation mode the wattage selected in the power setting

menu is applied to the coil, unless there is a power limitation due to a

condition described above under "notes to very high power vaping".

1. Temperature controlled vaping

In this mode the mod will regulate the temperature of the coil to the pre-set

value,except the power setting is too low to achieve the temperature. So

please note to adjust the power setting to a value high enough, if you choose

temperature controlled vaping. Otherwise the temperature regulation changes

to a temperature limitation mode.

When HCtrl is set to TmpCtrl, the menu directly jumps to the selection of the

wire type. Here the user can select between dicodes-wire (NiFe30),

Nickel 200 (Ni), Titanium (Ti), several sorts of stainless steel, NiFe48 and

"Other". With "Other" selected, the temperature coefficient defined in the

Extended Functions / Heater Menu under item "Temp. Cof" is used. The value

of the selected coefficient is displayed behind "Wire".