dicodes Dani Box Manual - Page 11

Browse online or download pdf Manual for Vaporizers dicodes Dani Box. dicodes Dani Box 14 pages.

Print Page

06 Extended Functions Menu

Additional Explanation to several menu items, page 1

The following explanations are given for those parameters and items which are not self-explanatory or

have inter-dependencies with other parameters or functions.

The selection of the correct wire-temperature-coefficient is very important for the

correct operation of the mod—especially when Temperature Controlled Vaping is

selected.

As soon as TC-mode is selected, a multiple choice list of commonly used wires types is

provided along with predefined coefficients is displayed. There is also the category—

"Other".

The coefficient of this "Other" wire can be adjusted in this menu item. Note that stainless steel and

titanium wires often do not have well defined coefficients. The TCoef item in the menu is visible, even if

the operation mode is not set to Temperature Controlled Vaping.

The Power Limit has an effect on several functions of the mod:

1. Power Limit defines the adjustment range of the power in the main menu. As stated

the limit value sets the roll-over or stop point of the menu "Power". The power

limitation makes sense especially in the standard vaping mode in order to prevent coil

breaks when using small atomizers and small coils.

Power Limit sets the power during the boost-phase in the Power Boost Mode.

All dicodes devices allow the user to set the minimum discharge level of the battery

between 2.5V and 3.0V (older models 3.5V). Almost all batteries specify a minimum

discharge level of 2.5V to 2.7V. If the user is unsure of the minimum discharge level of

their battery, it should be set to 2.7V.

The selected voltage is the voltage at the poles of the battery when current is drained from it (the

current drained depends on the power at the coil). In contrast to other tube and box mods—which

stop operation already at 3.4V—the lower discharge level allowed by dicodes mods leads to better

battery utilization (about 20% better).

Note that at UBatMin+ 0.5V the power reduction function is activated depending.

The time to automatic power off of the mod can be selected from 1 minute up to 60

minutes. We recommend selecting 2 or 5 minutes so the mod is always ready to vape,

when the fire button is pressed. Either of these settings also provides the best

utilization of the battery.

NOTE: If the mod was actively switched off by the user—by clicking the fire button 5 times—the instant

power on is not available. In this case the mod has to be switched on with 5 clicks first.

The display mode (DispMod) switches on and off the display of several parameters

during and after the puff. The setting "cont" (continuous) will display values during and

seconds after the vape. With "post" the values are displayed only after the puff. "Off"

disables the display.

The values shown depend on the operation mode. In Temperature Controlled mode the parameters are

the temperature, coil resistance, temperature regulating power and a battery symbol.

For standard, boost and heater protection mode the parameters shown are the selected power (static,

no change), the coil resistance and the battery voltage. When Bypass mode is selected the display

shows the coil resistance, the battery voltage dependent and the calculated power (as there is no fixed

power setting in bypass mode).