EPCOM Industrial GT003G User Manual - Page 2

Browse online or download pdf User Manual for Outdoor Storage EPCOM Industrial GT003G. EPCOM Industrial GT003G 2 pages. Outdoor cabinet, post or wall mounting. supports 3 batteries and solar control equipment. made of galvanized sheet.

Print Page

Introduction

Thank you for adquiring this cabinet GT003G. The information contained in this

manual will help you in the product assembly besides describing all physical

characteristics, included parts and recommendations for its use and installation.

Recommendations

Install equipment until you have finished installing the cabinet.

Select the appropriate anchor according to the wall material. In adobe walls or

other material that is not concrete, it is recommended to pass the anchor of the

cabinet to the other side of the wall and secure on both sides.

Tool

- 7/16" wrench or socket.

- Cross and flat screw.

- 1/2" wrench or socket.

- 5/8" wrench.

Assembly mode

1. Start by physically identifying the parts that make up the cabinet. When

screwing, do not tighten the screws if not until you have tied all the pieces.

2. Only 7/16" screws, nuts, will be used in cabinet assembly they have an anti-

skid system, so it is recommended to place them in the most difficult sections

to reach.

3. Place the back cover (E) on a flat surface and screw the sides (C and D)

to it.

4. Locate the brackets (G and H) in the internal holes of the flange each side

(C and D) respectively and screw them together to the back cover (E).

5. Screw the cover (A and B) to the sides.

6. Locate the sloping lid M on the top of the cabinet and secure it with nuts

and bolts.

7. With each panel (F) turned, locate the screws and place the plate (I) by

screwing their respective nuts to each one, place them on the panel supports

(G and H).

8. Place the battery holders (K) on the inside of the cover (A) as shown in the

image.

9. Assemble filter covers (O) onto the cover (A) by inserting one corner into a

slot and pressing so that the filter cover is slightly bent and it is possible to insert

the other corner into the corresponding slot.

10. Finally, place the door (J) on the armed cabinet.

Wall mounting

1. Once the ideal anchor is defined according to the wall material, proceed to fix

the assembly (L) to it.

2. Screw 2 1/2 "screws and washers to the upper side nuts (C and D) with a few

turns on the outside.

3. Seal the screws in the assembly (L) ensuring the stability of the cabinet.

4. Screw the cabinet to the mounting by placing the 2 1/2 "screws to the bottom

nuts on the sides (C and D).

5. Tighten all screws.

Post mounting

1. Using the 5/8 "threaded rods, nuts and washers and the clamps (N), secure

the mounting (L) to the tower or post.

2. Continue following from step 2 of "Wall mounting".

3. Be sure not to exceed the load capacities of the tower or pole.

Rack

Inclined Cover M

Support G

Cover B

Side Panel C

Rack F

Plate I

Door J

Battery Support K

Filter Cover O

Assembled without door

Back cover E

Threaded rod P

Clamp N

Cover A

Rack

Support H

Mounting L

Side Panel D