Dictator E8 Technical Manual - Page 13

Browse online or download pdf Technical Manual for Control Systems Dictator E8. Dictator E8 19 pages.

Print Page

Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 20200703

III. Adjustment / Programming - cont.

„P-9" Adjustment of the position control system: position

„Crawling speed CLOSE"

When reaching this position the control system automatically reduces

the speed to a slower speed (set in the control system, not adjustable).

The indicated value shows at what distance (in cm) before the position

Door CLOSED the speed is reduced.

If the closing speed should not be reduced before the position Door

CLOSED the value has to be set to „000".

„P-A" Function of STOP 3 (safety element)

The parameter „P-A" determines the function of the STOP 3. The STOP

3 is especially provided for the connection of safety equipment.

Value 000:

STOP 3 interrupts the closing. When the obstacle has

disappeared the door will - after about 4 sec. -

automatically continue to close.

Value 001:

STOP 3 interrupts the closing. The door stops and then

automatically opens again completely. If the automatic

closing is ON the door will start closing after the preset

time (see parameter „P-5").

IMPORTANT: this funcion (001) is only possible when

the operating mode is adjusted to impulse operation

(see point VI Configuration of the DIP-Switches).

„P-b" Adjustment of the position control required: drive

unit with integrated position control system or

separate limit switches

The parameter „P-b" is provided for the distinction between a drive

unit with integrated position control system or the use of separate limit

switches.

Value 000:

Drive unit with integrated position control system

(ATTENTION: adjust the parameters P-6 to P-9)

Value 001:

Connection of separate limit switches

NOTE:

The display of the control system E8 normally always shows the parameter

P-0, i.e. the present position of the door.

Technical Manual E8

Page 05.023.13