EPH Controls RFRP-OT Operating Instructions - Page 3
Browse online or download pdf Operating Instructions for Thermostat EPH Controls RFRP-OT. EPH Controls RFRP-OT 4 pages. Wireless room thermostat
RFRP-OT Room Thermostat
RFRP-OT Room Thermostat
15. Boost function
The thermostat can be boosted to a speci c temperature for 1, 2 or 3
hours while the thermostat is operating in all modes except for holiday
mode.
Press the 'BOOST' button 1, 2 or 3 times, the time that the boost will be
activated to will ash on the screen.
If you do not press any other button the boost will activate to the
temperature displayed on the screen after 5 seconds.
If you press the 'OK' button the temperature will now ash. You can edit
the temperature if you press the
Press the 'OK' button or wait for 5 seconds to enter BOOST Mode.
'BOOST TO' will now be displayed on the screen with the time that it is
activated to displayed above this text.
Press the 'BOOST' button again to deactivate the boost.
16. Holiday function
This will switch your heating system o between the start and end times
you select .
Press the 'HOL' button, 'HOLIDAY FROM' will appear on screen.
Press the
or
buttons to adjust the day.
Press the
or
buttons to adjust the month. Press the 'OK' button.
Press the
or
buttons to adjust the year.
Press the
or
buttons to adjust the hour.
'HOLIDAY TO' will appear on screen.
Press the
or
buttons to adjust the day.
Press the
or
buttons to adjust the month. Press the 'OK' button.
Press the
or
buttons to adjust the year.
Press the
or
buttons to adjust the hour.
The thermostat will now return to the mode it was in before the Holiday
settings were entered.
To cancel Holiday mode, press the 'HOL' button.
17. To connect the RFRP-OT thermostat to an
RF1A-OT receiver
Please note, If you are installing a CombiPack4 the RFRP-OT thermostat and
the RF1A-OT receiver will have a pre-established RF connection so it is not
necessary to carry out the RF connection process below.
On the RF1A-OT receiver:
Press the
button on the RF1A-OT receiver.
Connect
The red light will begin to ash.
On the RFRP-OT thermostat:
Press the
button.
Connect
The thermostat will show "nOE" followed by "---"
Once an RF connection has been established the thermostat will show 'r01'
on the LCD screen.
Press the 'OK' button to nish the process.
The thermostat is now connected to the RF1A-OT receiver.
or
buttons.
Press the 'OK' button.
Press the 'OK' button.
Press the 'OK' button.
Press the 'OK' button.
Press the 'OK' button.
Press the 'OK' button.
EPH Controls Ireland
[email protected] www.ephcontrols.com
Boiler
Plus
Wireless
Wireless
18. To disconnect the RFRP-OT thermostat from an
RF1A-OT receiver
This can be done from either the thermostat or the receiver.
18.1 On the RFRP-OT thermostat:
Press the
Connect
The thermostat will begin to search through the RF channels.
Press and hold the 'Copy' button for 10 seconds.
'Adr' will appear on the screen of the thermostat.
Press the 'OK' button twice to complete the unpairing process.
The thermostat RFRP-OT is now disconnected from the receiver RF1A-OT.
18.1 On the RF1A-OT receiver:
Press the
button, the red light will ash.
Connect
Red & green lights if using as a hub receiver.
Press and hold connect for about 10 seconds, the receiver will then stop
ashing.
The RF connection is now cleared.
19. Backlight mode selection
There are two settings for selection. The factory default setting is AUTO.
OFF
The backlight is permanently OFF.
AUTO
On pressing any button the backlight stays on for 5 seconds.
To adjust the backlight setting, lower the cover on the front of the unit.
Press the 'OK' button for 5 seconds.
Press either the
Press the'OK' button.
20. Battery low warning
When the batteries are almost empty, the
the screen.
The batteries must now be replaced or the unit will shut down.
21. Replacing the batteries
Lower the ap at the front of the thermostat.
There is a battery compartment located below the buttons.
Apply downward pressure to remove the cover.
Insert the 2 x AA batteries and the thermostat will turn on.
Close the battery compartment.
EPH Controls UK
[email protected] www.ephcontrols.co.uk
Page 3 of 4
Operating Instructions
button.
AUTO
buttons to select the OFF or AUTO mode.
or
symbol will appear on
20190627_RFRP-OT_OpIns_JW