DieHard 200.71234 Owner's Manual - Page 5
Browse online or download pdf Owner's Manual for Battery Charger DieHard 200.71234. DieHard 200.71234 15 pages. Battery charger 6012012 amp fully automatic; 275/125 amp engine starter with battery tester and gfci outlets
Also for DieHard 200.71234: Owner's Manual (15 pages)
Print Page
Before Using Your Battery Charger
It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground
and connect the power cord, and prepare to charge a battery.
Assembling your charger
It is important to fully assemble your charger before use.
Follow these instructions for easy assembly.
PARTS:
Two, 10-32 thread cutting
screws
Two, 1/4-20 thread cutting
screws
Two wheels
One axle
Two axle caps
Two axle brackets
One handle
One handle grip
One mounting foot
Attach Foot:
Remove charger from packing materials and place
charger on its side. Attach mounting foot and secure
with the two, 1/4-20 thread cutting screws provided.
Axle Assembly:
Hold axle upright on floor or work surface. Then, using
a hammer, tap one of the axle caps onto
the top end of the axle. Be sure to tap the hub on
straight. Slide both wheels onto the axle with the
hubs facing inward. Tap the other axle cap onto the
opposite end of the axle and place the axle assembly
onto the bottom of the charger.
TOOLS NEEDED:
3/8" wrench
(for mounting foot)
5/16" wrench
(for wheels)
Hammer
Phillips screwdriver
4
continued on next page