DieHard 200.713201 Owner's Manual - Page 5
Browse online or download pdf Owner's Manual for Battery Charger DieHard 200.713201. DieHard 200.713201 16 pages. 20/15/10/2 amp fully automatic battery charger
Also for DieHard 200.713201: Owner's Manual (16 pages)
Print Page
It is important to understand
your charger's
requirements.
This section will tell you
about your charger's electrical
requirements
and how to prepare a battery for
charging.
ASSEMBLINGYOURCHARGER
Included with your battery charger are
two cord wrap posts for storage of the
clamp cables.
To install, align the three tabs to
correspond
with the three receptacles
and push until you hear a snap.
Wrap clamp cord after unplugging
the
power cord and store your charger in a
dry location.
[_
(--Cord Wrap Cleat
PLUGGING
IT IN
WARNING:
Electrical Shock Hazard.
Be sure that the power cord fits properly
into the outlet. If not, have a qualified
technician install a proper outlet. Never
alter the AC cord or plug provided.
Improper connection can result in
electrical shock.
Your charger requires a 120V receptacle
installed according to all local codes and
ordinances.
I
!111k
USING AN EXTENSION
CORD
The use of an extension cord is not
recommended.
If you must use an
extension cord, please make sure
that you follow these guidelines:
•
Make sure that the pins on charger's
power cord fit firmly into the extension
cord, and that the extension cord fits
firmly into the receptacle.
• Check that the extension cord is
properly wired and in good electrical
condition.
Make sure that the wire size is large
enough for its length and for the AC
ampere rating as specified in the chart
below.
iLength
of Cord, in Feet
25
50 100
150
AWG* Size of Cord
18
16
12
10
*AWG=American Wire Gauge