DieHard 28.71221 Operator's Manual - Page 10
Browse online or download pdf Operator's Manual for Battery Charger DieHard 28.71221. DieHard 28.71221 11 pages. 12v manual battery charger
Print Page
14.
MOVINg AND STORAgE INSTRUCTIONS
14.1
Store the charger unplugged, in an upright position. The cord will still conduct electricity
until it is unplugged from the outlet.
14.2
Store inside, in a cool, dry place.
14.3
Do not store the clips on the handle, clipped together, on or around metal, or clipped
to cables.
14.4
If the charger is moved around the shop or transported to another location, take care to
avoid/prevent damage to the cords, clips and charger. Failure to do so could result in
personal injury or property damage.
15.
TROUBLEShOOTINg
PROBLEM
The charger will not turn on,
there is no reading on the
ammeter or the charger is
not charging the battery.
Ammeter reading stays high.
Ammeter reads less than
selected charge rate when
charging a discharged
battery.
POSSIBLE CAUSE
Charger is not plugged in.
No power at the receptacle.
Poor electrical connection.
Clips are not making a good
connection to the battery.
Connections are reversed.
Battery is defective (will not
accept a charge).
2 amp charge rate is being
used.
Battery is severely
discharged.
Wrong battery voltage.
Extension cord is too long or
wire gauge is too small.
Weak cell or sulfated plate in
battery.
Battery is only partially
discharged.
8
•
•
REASON/SOLUTION
Plug the charger into an AC
outlet.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and
extension cord for loose fitting
plug.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock the clips back and forth
for a better connection.
Unplug the charger and
reverse the clips.
Have battery checked.
Ammeter may show no activity
at the 2A charge rate.
Continue charging battery for
two more hours. If problem
continues have the battery
checked.
Verify that the voltage settings
on the charger are correct.
Use a shorter or heavier
gauge extension cord.
If the battery will not take a
charge, have it checked.
Continue to charge the
battery.