Olympus CX31 Instructions Manual - Page 9

Browse online or download pdf Instructions Manual for Microscope Olympus CX31. Olympus CX31 24 pages. Biological microscope

Print Page

3 3

ASSEMBLY

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Mounting the Bulb (Replacement of Bulb)

1. Turn the microscope frame on its side and pull the lamp housing

knob @ on the underside of the base to open the lamp housing cover.

2. Holding the halogen bulb ² contained in the polyethylene bag to

avoid leaving fingerprints on the bulb, fully insert the contact pins into

the bulb socket ³. When properly seated, pull off the polyethylene bag.

6 V, 30 W halogen bulb: 6V30WHAL (Philips 5761)

Always use the designated bulb. Use of improper bulb may result

in fire.

Do not touch the bulb with bare hands. If fingerprints are

accidentally left on the bulb, wipe the bulb with a soft, lint-free

cloth moistened with alcohol. Using a contaminated bulb will

shorten the service life of the bulb.

3. With the lamp housing knob still pulled out, close the lamp housing

cover. Then push in the lamp housing knob to lock the cover.

#The lamp housing cover cannot be closed if the knob is pushed in

before you attempt to close the cover.

Caution for Bulb Replacement During Use or Right After Use

Whenever you replace the bulb during use or right after use, first

move the main switch to "

from the wall outlet, and allow the bulb and parts around the bulb

to cool before touching.

#If the bulb burns out during an observation and needs to be

replaced, remove the specimen, filter and other objects likely to

fall off, before tilting the microscope frame to replace the bulb.

Connecting the Power Cord

Cables and cords are vulnerable when bent or twisted. Never

subject them to excessive force.

Make sure that the main switch @ is set to "

connecting the power cord. (Fig. 4)

Always use the power cord provided by Olympus. IF no power

cord is provided with the microscope, please select the proper

power cord by referring to section "PROPER SELECTION OF THE

POWER SUPPLY CORD" at the end of this instruction manual.

1. Connect the power cord plug ² to the AC receptacle ³. (Fig. 5)

Connect the power cord to a grounded, 3-conductor power outlet

and ensure that the ground terminal of the power supply and that

of the wall outlet are properly connected. If the equipment is not

grounded, Olympus can no longer warrant the electrical safety

performance of the equipment.

2. Plug the power cord plug | into the wall outlet ƒ. (Fig. 6)

(Fig. 3)

" (OFF), disconnect the power cord

(Figs. 4 - 6)

" (OFF) before

CX31