Olympus PFL-E01 Instruction Manual - Page 18

Browse online or download pdf Instruction Manual for Camera Accessories Olympus PFL-E01. Olympus PFL-E01 29 pages. Electronic flash waterproof case for the fl-36

Print Page

Check the loading status.

Always perform the following final checks before sealing the Case.

･ Is the electronic flash attached firmly to the hot shoe of the Case?

･ Is the silica gel inserted all the way at the specified position?

･ Is the O-ring installed properly?

･ Are the O-ring and the O-ring contact surface free of dirt and other foreign matter?

Seal the Case.

Close the rear lid (gently, so that the O-ring

will not come out of the groove), engage the

buckles with the hooks on the rear lid, and

push the buckle lock/unlock levers down in

the direction of the arrows. The Case will be

sealed airtight.

CAUTION

：• Seal the Case by pushing all three buckle lock/unlock levers down in the

direction of the arrows.

• If one of the buckles is left open, the Case will not be sealed properly and

water leaks will occur.

Perform the final checks.

Visual inspection

After sealing the Case, visually examine the sealed sections on the front and rear lids to

confirm that the O-ring is not twisted or out of the groove and that no foreign matter has

been caught.

CAUTION

：• Hairs, fibers and other small items are not easy to see, but they may allow

water to get inside, so that special attention is required.

Switching the electronic flash on

Press the power button and confirm that the electronic flash power is switched ON/OFF.

Turn the select dial and confirm that the electronic flash mode dial is set to the TTL AUTO

or MANUAL position.

CAUTION

：• After loading the electronic flash in the Case, confirm that the select dial is

rotatable. If not, there may be oil or grease on the dial knob. Wipe it off

completely.

E-16