Olympus U-DO3 Instructions Manual - Page 31

Browse online or download pdf Instructions Manual for Laboratory Equipment Olympus U-DO3. Olympus U-DO3 40 pages. For 2, 5, 9, 10 and 13 persons
Also for Olympus U-DO3: Instructions Manual (18 pages)

Print Page
Olympus U-DO3 Instructions Manual
c
1
b
a
1
a
3

Attaching the light path split unit

a
1
Attach the light path split unit a provided with U-MDO10R-3 to the
top of U-MDO10R-3 (at assistant observer position), and tighten the
clamping screw b to secure the light path split unit.
TIP
4

Attaching U-MDO10B3

c
1
Attach U-MDO10B3 a on the top of U-MDO10R-3 (at main observer
b
position) and tighten the clamping screw b to secure U-MDO10B3.
TIP
5

Attaching the stand

Height of the a portion of the stand
The height of the a portion of the stand to be adjusted after screwing
the stand into U-MDOSV is 69 mm.
TIP
For attaching procedures, see "Attaching the stand" in "5-2 Side by
side observation system for 2 persons and system for 5 persons"
(page 18).
6

Attaching U-MDOSV

See "Attaching the side viewer" in "5-2 Side by side observation
system for 2 persons and system for 5 persons" (page 19).
Attach the light path split unit a so that the clamping screw
b of U-MDO10R-3 and the clamping screw c of the light
path split unit are aligned in one line perpendicularly.
Attach U-MDO10B3 a so that the clamping screw b of
U-MDO10R-3 and the clamping screw c of U-MDO10B3 are
aligned in one line perpendicularly.
If there is a difference in height between the desk top surface
where the microscope frame is installed and the desk top
surface where U-MDOSV is installed, adjust the length of the
a portion of the stand. For example, if the height difference
is 5 mm (if the desk top surface of the microscope frame is
higher than the desk top surface to install U-MDOSV), a will
be 74 mm.
27